Best sellers
There are 15591 products.
Diagnostic interface for wireless diagnostics of cars with OBD2 system. The device uses the popular 16-pin connector and is equipped with a Bluetooth 3.0 module. Vgate iCar2 ELM327
Module with IMX462 sensor working with Raspberry Pi and Jetson Nano. It has a 2 MP matrix and a lens with a 99° angle of view. Waveshare IMX462-99 2MP Starlight Camera
Module with a camera with a resolution of 2 MP OV2640 and a Himax HX6537-A processor. Dedicated to applications that use artificial intelligence in image processing. Seeed Studio 114992866
SDR (software-defined radio) receiver with frequency range from 500 kHz to 1766 MHz. It can work as a radio receiver or a broadband scanner. RTL SDR RTL2832U
Robot controller dedicated to Totem sets. It is based on the ESP32 chip (WiFi and Bluetooth module), equipped with a DC motor and servo driver, RGB diodes and an IMU sensor. With DC adapter. Totem TE-X4-KIT2
Laboratory power supply with smooth voltage regulation in the range from 0 to 15 V and two values of constant current: 1 A and 5 A. Equipped with USB fast charging function. WEP 1505D
Air quality sensor module based on the SGP40 system. It communicates via the I2C interface. DFRobot SEN0392
OLED display with a diagonal of 1.3" and a resolution of 128x64 pixels. Designed for use with Feather series plates. Adafruit 4650
Multifunctional expansion module dedicated to micro: bit V2. DFRobot MBT0042
Li-Po battery with a rated voltage of 3.7 V and a capacity of 1850 mAh, equipped with a PCM protection and a 2.5 JST-RCY connector. Akyga LP704452
Base board dedicated to Raspberry Pi CM4 modules. It is equipped with two RJ45 connectors, USB 2.0 and a microSD slot. Additionally, there is a fan connector on the board. Waveshare CM4-DUAL-ETH-MINI
Module with two DRV8830 DC motor drivers. The board is equipped with a Grove connector and communicates via the I2C interface. Seeed Studio 105020010
The trigger module is designed for chargers PD 2.0 and PD 3.0. It is equipped with a USB type C input and an output in the form of pads. Allows powering devices with 9V. PDC004
Yellow mounting for Grove modules, which ensure convenient installation and replacement of modules in the project. Compatible with LEGO. Set of 4. Seeed Studio 110070025
Module with a 16-channel PWM PCA9685 driver. The board is equipped with a Grove connector and communicates via the I2C interface. Seeed Studio 108020102
Module with Sensirion SCD30 sensor, which enables CO2, temperature and humidity measurement. The board is equipped with a Grove connector and communicates via the I2C interface. Seeed Studio 101020634
Stereo audio amplifier with Bluetooth 4.0 communication. It can be powered with 12 V and has two 25 W outputs
Module with 42 RGB LEDs WS2813 Mini. The board is equipped with a Grove connector and communicates via a digital interface. Seeed Studio 104020173
Red mounting for Grove modules, which ensure convenient installation and replacement of modules in the project. Compatible with LEGO. Set of 4. Seeed Studio 110070020
Module with a pressure sensor with high accuracy HP206C. The board is equipped with a Grove connector and communicates via the I2C interface. Seeed Studio 101020068