Best sellers
There are 12466 products.
Antenna with RP-SMA male plug operating in the 433 MHz frequency band. It has a gain of 5 dBi. Included with RP-SMA - u.FL adapter
Collective work edited by Marek Węgrzyn, Janusz Jabłoński and Marcin Nowakowski
Sn99.3Cu0.7 SW26 solder, produced by Cynel-Unipress, is a lead-free, rosin-based alternative to traditional fillers, meeting ISO 9453:2014 standards and the RoHS directive, ideal for professional and amateur soldering applications
Module with PIR motion sensor SR-602. It can detect movement up to 5 meters
Female terminal block, angled, 6-pin. Pitch 5.0mm. Height 15mm. 2EDGK-5.0-6P
Yellow LED (529nm) with 1W power equipped with a heat sink. Brightness approx. 30lm, viewing angle 120 degrees.
Permanent cylindrical neodymium magnet with a diameter of 12 mm and a height of 1 mm. Set of 10 pcs
A connector that allows you to connect the cable to the existing installation without having to cut the cable. Suitable for wires with a cross-section of 2-4mm2
Reflective Optical Sensor with Transistor Output, Vishay, RoHS
StarSBC series minicomputer with NXP i.MX6 ULL Y2 792MHz processor (Cortex-A7 core), 512MB RAM, 8GB eMMC memory, built-in WiFi and Bluetooth wireless and wired Ethernet connectivity. SoMLabs SLC2X6Y2_792C_512R_08GE_3WE_E
Translator of TI voltage levels, bidirectional (no signal required to control the flow direction), 8-Bit, especially recommended for use in Push-Pull and Open-Drain systems. The system has a TSSOP20 housing
Protection circuit for four Li-Ion cells with a voltage of 14.8V. The module has the function of charging cells with the option of a balancer, discharging and a function that protects the cells from excessive discharge. The cells can be charged with continuous current up to 10A
15A car fuse is a key protection element for vehicle electronic systems, supplied in a set of 10, small in size and easy to replace
VisionCB-RT-STD is a base plate for VisionSOM-RT modules (i.MX RT). The tile contains, among others Ethernet, USB connectors, connectors compatible with Arduino shields and Raspberry Pi hat, 5 buttons and 5 LEDs. VisionCB-RT-STD, SoMLabs
Bluetooth 4.2 audio receiver with 3.5 mm jack audio output. It allows you to play files via Bluetooth and supports WAV, WMA APE, MP3 and FLAC formats. MH-M28
Temperature sensor based on a DS18B20 chip replacement. It is enclosed in a waterproof measuring probe. It has a 2 m cable and communicates via a 1-Wire interface
USB TO UART solution with USB Type A connector, Waveshare
3-wire cable, 10 cm long, with a micro 5264 female plug at both ends