Adapter for Raspberry Pi - Explore R

Atmel ATmega32U4 microcontroller comes preloaded with an Arduino-compatible bootloader, and the board includes dual motor drivers that can deliver 1.7 A per channel to two brushed DC motors. Pololu 3119

The 4-port HUB module with USB 3.2 interface is designed to work with the Raspberry Pi minicomputer. Waveshare USB 3.2 Gen1 HUB HAT

2.8" IPS LCD display with touch screen. The display is equipped with a DPI interface for image display and I2C interface for a touch screen. Resolution 480x640 pixels. Waveshare 2.8inch DPI LCD

RTC clock module with a built-in Watchdog system dedicated to projects based on Raspberry Pi minicomputers. It is equipped with an advanced monitoring circuit with the CH32V003 chip, which allows for automatic reset in the event of system malfunction or freeze. Waveshare RTC Watchdog HAT (B)

E-ink display for Raspberry Pi with 2.13 "diagonal resolution and 250x122 pixels with SPI controller. DFRobot DFR0591

Module with e-Paper display, 10.3" diagonal and 1872x1404 px resolution. Communication via USB, SPI or I80 interface. Waveshare 10.3inch e-Paper HAT

This compact expansion board plugs directly into the GPIO header on a Raspberry Pi B+, A+, or Pi 2 and provides an easy and low-cost solution for driving a pair of small brushed DC motors. Pololu 2753

A 4-channel power parameter monitoring module dedicated to Raspberry Pi minicomputers. Allows voltage, current and power monitoring via I2C or SMBus. Waveshare Current/Power Monitor HAT

Expansion board with LoRa E22-400T22S module for Raspberry Pi. It supports the LoRaWAN protocol and allows communication in the 433 MHz frequency band. SB Components 22564

HAT module designed for the Raspberry Pi minicomputer. It allows you to add an RS485 interface and a CAN bus to the project, allowing for wired communication of many devices over long distances. SB Components 21444

This add-on board makes it easy to control two high-power DC motors with a Raspberry Pi. Its twin discrete MOSFET H-bridges support a wide 6.5 V to 30 Voperating range and are efficient enough to deliver a continuous 18 A without a heat sink. The drivers offer basic current limiting functionality, and they accept ultrasonic PWM frequencies for quieter operation. 

GNSS module based on the L76B chip that can work with GPS, BDS and QZSS systems. Communication via a UART interface. SB Components 24056

Audio module with DAC, line output and display, designed to work with the Raspberry Pi. Pimoroni PIM483

The DFRobot IO Expansion HAT module provides additional digital, analog, I2C, PWM, UART and SPI outputs. Thanks to its small size, it fits perfectly with Raspberry Pi Zero and Zero W. DFRobot DFR0604

Module with a capacitive fingerprint sensor for the Raspberry Pi. It communicates via the UART or USB interface. SB Components 21253

Board with the NB-IoT SIM7020E module for the Raspberry Pi. It communicates via the UART interface and AT commands. Waveshare SIM7020E-NB-IoT HAT