New products
New products
zł67.99
24h
Available
zł69.00
24h
Available
zł67.99
24h
Available
Available
zł79.00
24h
Available
zł67.99
24h
Available
zł69.00
24h
Available
zł67.99
24h
Available
Available
zł79.00
24h
Available
Gravity: 315MHZ RF Receiver Module
ID: 565771
zł33.97
Tax included
zł27.62 tax excl.
DFRobot 315MHz RF receiver module using SC2272-L4 low power decoder chip. DFRobot TEL0112
INTRODUCTION:
The 315MHz RF receiver module is widely used in the field of vehicle Telecontrol, access control system, identification, etc. Compared with traditional wired communication, RF radio has advantage of higher flexibility and lower maintenance cost.
DFRobot 315MHz RF receiver module using SC2272-L4 low power decoder chip, with 8-bit three-state address coding switch, each one has three states: high level, low level, floating empty, so it supports up to 6,561 of the coding address. Modules can be used with SC2260, SC2262, PT2260, PT2262 and other coding chips, recommend our Remote Wireless Keyfob (315MHz)
APPLICATIONS:
SPECIFICATION:
SHIPPING LIST:
Gravity: 315MHZ RF Receiver Module x1
565771
Responsible person BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
You might also like
Expansion board for Arduino, allows easy connection of XBee modules, has separate outputs for I2C, SPI and UART buses. The built-in 3.3V voltage stabilizer and operating mode switch make it easier to program the Arduino when the XBee module is connected to the sockets. DFRobot DFR0265
zł24.12 24hAvailable quantity: 3 AvailableGravity: IO Expansion & Motor Driver Shield is an Arduino compatible expansion board that provides digital I / O ports, analog I2C, SPI and UART interfaces, as well as a DC motor driver. DFRobot DFR0502
zł65.65 24hAvailable quantity: 4 Available
Other products in the same category (16)
HAT module with RFM95W 868 MHz system for LoRa/LoRaWAN communication and OLED display, designed for Raspberry Pi minicomputers. Adafruit 4074
zł197.59 24hAvailable quantity: 2 Available6-channel transmitter (RC apparatus) 2.4 GHz Flysky FS-i6 with LCD display in set with receiver FS-IA6 with telemetry support. 6V power supply (4 x AA battery). Left-hand throttle (right-handed version). Flysky FS-i6
zł252.88 6 weeks No product available!
Multi-channel wireless data transmission module operating at 433 MHz. It is supplied with the voltage ranging from 3.2 V to 5.5 V and communicates via the UART interface
zł23.78 24hAvailable quantity: 36 AvailableA set with a radio transmitter and receiver operating at 433 MHz. The modules are equipped with Grove connectors and communicate via a digital interface. Seeed Studio 104020002
zł62.15 24hAvailable quantity: 2 AvailableLong-range Sub-GHz wireless RF transmitter and receiver module, capable of operating in the 433 MHz frequency band. The integrated architecture allows the use of a minimum number of external components while maintaining maximum design flexibility. Hoperf RFM69HW-433S
zł18.91 24hAvailable quantity: 8 AvailableRadio module with RFM69HCW 433 MHz chip, designed to work with the Raspberry Pi. Equipped with an OLED display and buttons. Adafruit 4073
zł144.14 24hAvailable quantity: 2 Available No product available!
Wireless switch operating at 433 MHz frequency. It does not require a power supply. DFRobot TEL0146
zł44.65 24hAvailable quantity: 4 Available- Available
2.4 GHz RF module with nRF24L01+ chip. The module has an RP-SMA connector with reverse polarity, allowing the connection of an external antenna. The system has a built-in 3.3 V stabilizer and IO lines with a tolerance of 5 V. SparkFun WRL-00705
zł155.41 24hAvailable quantity: 1 AvailableModule with a 433 MHz radio receiver for M5Stack sets. Based on the SYN531R chip, it has a built-in PCB antenna. M5Stack U113
zł26.94 24hAvailable quantity: 8 Available- Available
A set with a radio transmitter and receiver operating at 315 MHz. The modules are equipped with Grove connectors and communicate via a digital interface. Seeed Studio 113020001
zł50.26 24hAvailable quantity: 3 AvailableThe NRF24L01+ chip module for radio communication, which operates in the 2.4 GHz ISM band. It is used in various applications such as wireless sensors, remote control, wireless networks. It supports the Enhanced ShockBurst protocol, which provides automatic packet handling. It communicates via an SPI interface
zł12.36 24hAvailable quantity: 20 AvailableModule with nRF24L01 + transceiver, power amplifier and antenna with 2dBi gain, 1000m, 2Mb / s, RoHS
zł12.89 6 weeks No product available!
Wireless transceiver operating in the 915MHz band based on the RFM69HCW chip with a maximum power of 100mW and a transmission speed of up to 300kbps. The range in open space is up to 500m. The module communicates via the SPI bus. Arduino compatible. modRFM69HCW_915MHz
zł23.28 6 weeks No product available!
DFRobot 315MHz RF receiver module using SC2272-L4 low power decoder chip. DFRobot TEL0112