New products
New products
zł59.04
Delivery date unknown
zł62.71
24h
Available
CAB_HU06-30
ID: 133613
zł7.90
Tax included
zł6.42 tax excl.
30 cm HU06 cable
Free shipping
free shipping in Poland for all orders over 500 PLN
Same day shipping
If your payment will be credited to our account by 11:00
14 days for return
Each consumer can return the purchased goods within 14 days
30 cm HU06 cable.
133613
You might also like
Available
Available
Development kit with STM32L496ZGT6 microcontroller (ARM Cortex-M4 core) with a built-in ST-Link programmer. Extensive equipment, including: MEMS 6DoF sensor, motor controller, joystick, LED display, 8 LED diodes, RGB LED, audio amplifier, Flash memory QSPI 1 MB, microphone, Arduino connector
zł400.60
24h
Available quantity: 1
Available
Development kit with STM32L496ZGT6 microcontroller with built-in ST-Link programmer. Extensive equipment, including: MEMS 6DoF sensor, motor controller, joystick, LED display, 8 LED diodes, RGB LED, audio amplifier, Flash memory QSPI 1 MB, microphone.
zł249.00
24h
Available quantity: 1
Available
Other products in the same category (16)
KAmodRPi-GPRS-GPS is an overlay for Raspberry Pi 4 / 3B + / 3B / 2B / B + computers, which allows you to enrich the system with the ability to send data via GPRS, SMS transmission or work as a module for Bluetooth communication. This extension also offers the ability to receive satellite data from location systems - GPS and GLONASS.
zł229.00
24h
Available quantity: 51
Available
KAmodPCA9533 is a module with LED driver from NXP. The module allows you to control the brightness of 4 LEDs using programmable PWM signals (with a frequency from 0.591 Hz to 152 Hz). I2C interface. The board is equipped with a Pmod I2C standard connector and a KAMAMI connector
zł14.90
24h
Available quantity: 269
Available
KAmodLIS35DE is a module with a three-axis LIS35DE accelerator from STMicroelectronics. The chip has a digital signal output (I2C or SPI bus) and allows acceleration measurement in three axes.
zł19.90
24h
Available quantity: 474
Available
KAmodL3GD20 is a digital gyroscope module with L3GD20 chip. It makes possible to measure angular velocity up to ± 2000 degrees per second. It has a embedded voltage regulator and level translators on SDA/SCL lines, thanks to which it can be used in systems supplied with a voltage of 2.5 V-5.5 V. KAmodL3GD20
zł39.90
24h
Available quantity: 112
Available
Four relay output module for Raspberry Pi 4B, Pi 3B+ Pi3B, Pi2, Pi+, Pi minicomputers.
zł31.89
24h
Available quantity: 192
Available
Available
Available
Available
Module with TCS3200D system - sensor of RGB light components
zł44.90
24h
Available quantity: 4
Available
RJ12 6-Pin PH 10-Pin IDC Adapter for PIC Microcontrollers Programming
zł17.90
24h
Available quantity: 60
Available
16-button 4 × 4 matrix keyboard module
zł39.90
6 weeks
No product available!
KAmodBT-HC05 is a Bluetooth module configured via AT commands. It has integrated LEDs indicating operating mode and connection status with the paired device, as well as a logic level translator on UART lines. KAmodBT-HC05
zł49.90
24h
Available quantity: 100
Available
Module with AT42QT1060 controller - contectless keyboard controller, Kamami, RoHS.
zł89.00
24h
Available quantity: 185
Available
zł6.88
24h
Available quantity: 486
Available
Module with digital thermal sensor, thermostat and I2C interface
zł24.90
24h
Available quantity: 191
Available
KAmodM41T82 is a module with the STMicroelectronics M41T82 RTC clock. The chip allows precise timing, and an additional battery connector allows you to maintain the power supply when the main power is turned off. Communication with the module is realized via I2C bus.
zł24.90
24h
Available quantity: 476
Available
30 cm HU06 cable