Screw Shield for Arduino

The module with connectors is dedicated to the Arduino Portenta boards. It helps in prototyping and testing connections. Arduino ASX00031

The expansion module (shield) is designed for Arduino boards. It enables easy connection of 16x32 and 32x32 matrix displays. Requires self-assembly. Adafruit 2601

Expansion board for Arduino, allows easy connection of XBee modules, has separate outputs for I2C, SPI and UART buses. The built-in 3.3V voltage stabilizer and operating mode switch make it easier to program the Arduino when the XBee module is connected to the sockets. DFRobot DFR0265

Controller module dedicated to Arduino boards. Equipped with 4 buttons, a two-axis joystick and an Xbee connector. DFRobot DFR0008

Multifunctional expander (shield) for NUCLEO and Arduino equipped with Bluetooth 2.0+EDR (HC-05) interface, MEMS 3DoF LIS35, LED-RGB, joystick and analog STLM20 temperature sensor developed and produced by KAMAMI.

Nano I / O Shield for Arduino Nano is an expansion board for Arduino Nano that provides digital, analog pins, power inputs and a connector for the Bluetooth module. DFRobot DFR0012

I/O pin expander designed for Arduino platforms. Provides 48 connections to increase the number of analog inputs, digital inputs and digital outputs. SparkFun DEV-11723

GPS expansion module with 72-channel GNSS receiver SAM-M8Q dedicated to Arduino. The chip can receive data from all major positioning systems: GPS, GLONASS and Galileo. It has derived UART and I2C interfaces. Arduino ASX00017

e-Paper display controller module with a standard Arduino connector. It has a built-in MX25R6435F Flash memory with a capacity of 8 MB and a 24-pin FFC connector dedicated to e-Paper displays. Waveshare e-Paper Shield (B)

Voltage divider module for measuring quantities in the 0V to 25V range.

Cap for Xbee and Arduino. It has been designed for wireless sensor networks such as WiFi, Bluetooth 2.0 / 4.0 and Zigbee. DFRobot DFR0015

Adafruit 493 - LoL Shield BLUE - A charlieplexed LED matrix kit for the Arduino - 1.5

Extension board for Arduino Nano and Uno, 14 GPIO lines, connectors with I2C and UART interface lines. The board also has a RESET button and a voltage stabilizer

The overlay solves the problem of limitations in the use of multiple overlays compatible with Arduino UNO R3. The board allows you to connect different shields without their mutual influence on each other (eg without conflict on the UART bus or GPIO lines). Extension dedicated for Arduino Mega and ADK devices. DFRobot DFR0256

4inch Touch LCD Shield for Arduino is an overlay with a 4-inch LCD display. The screen has a resolution of 480x320 pixels. Communication with the display is via the SPI interface. Waveshare 4inch TFT Touch Shield