Photodetector Breakout - heart rate monitor module with Qwiic connector

Advanced GNSS receiver based on the Quectel LG290P module, which supports four frequency bands: L1, L2, L5 and E6, enabling reception of signals from GPS, GLONASS, Galileo, BDS, QZSS and NavIC satellite systems. With support for SBAS and PPP, the module provides highly precise positioning, and the built-in anti-jamming unit minimizes electromagnetic interference, which ensures reliability in difficult conditions. The Qwiic connector allows easy integration with systems, and low power consumption makes it an ideal solution for applications requiring long-term battery operation. SparkFun GPS-26620

Module with a 3-axis MMC5983MA mega-meter. Equipped with a Qwiic connector, it communicates via the I2C interface. SparkFun SEN-19921

Shield designed for IoT applications with LTE CAT M1/NB-IoT SARA-R4 modem. The board is compatible with Arduino, allows you to add communication via cellular networks to Arduino boards. SparkFun CEL-14997

Module with PIR EKMC4607112K motion sensor, power consumption in standby mode up to 170 uA. The board communicates via I2C and is equipped with a Qwiic connector. SparkFun SEN-17374

GPS module with NEO-M9N 92-channel GNSS receiver. The system can receive data from all major positioning systems: GPS, GLONASS, Galileo and BeiDou. It has UART, I2C and SPI interfaces. SparkFun GPS-17285

GPS module with 72-channel GNSS SAM-M8Q receiver. The system can receive data from all major positioning systems: GPS, GLONASS, Galileo and BeiDou. It has UART and I2C interfaces. SparkFun GPS-15210

Module with the MCP9600 amplifier designed to work with a K-type thermocouple. The module has a screw connector for connecting this type of thermocouple. I2C communication. SparkFun SEN-16295

Module with 10 addressable RGB LEDs APA102C. Each of the LEDs is independently controlled via the I2C interface, and the line address is modified, so that the modules can be connected with each other. SparkFun COM-18354

Module with an infrared sensor MLX90640 - a measuring matrix with a resolution of 32x24 pixels. It offers an accuracy of 1.5°C and a viewing angle of 55x35°. Communication with the sensor takes place via the I2C interface. SparkFun SEN-14844

Flexible Qwiic cable, 150 mm long. On one side it is terminated with a female Qwiic connector, and on the other side with single female goldpin connectors. SparkFun PRT-17261

Qwiic adapter designed for micro:bit educational modules. Facilitates access to all pins that are led out on the connector with a pitch of 2.54 mm and the Qwiic connector. SparkFun BOB-16445

Shield with Qwiic connectors designed for Raspberry Pi minicomputers. It allows you to easily connect the minicomputer with the Qwiic sensor system. SparkFun DEV-15945

SEN-14347

Module with a capacitive touch sensor based on the CAP1203 chip. There are three touch panels on the board that can be used as separate sensors (pins CS1, CS2, CS3) or as a touch slider. I2C communication. SparkFun SEN-15344

Starter kit with Qwiic modules designed to work with the Raspberry Pi. The set consists of an overlay for Raspberry Pi with a standard 40-pin connector and four Qwiic connectors, OLED display, VCNL4040 distance sensor and environmental sensors. SparkFun KIT-16841

Module with 512 kbit (64kB) EEPROM. Communication is via the I2C interface. The module has 3 jumpers to select one of 8 addresses. SparkFun COM-18355