MS-DIP/PLCC6

Module with five reflection sensors. It has digital outputs and, thanks to the built-in microcontroller, enables calibration. Auto-Calibrating Line Sensor LSS05

HK TURNIGY Basic 25A v3.1 Speed Controller (3731)

Soldering station 5in1: hotair 100..480 degrees C, soldering tip 75W, power supply 0..15V / 1A, RF signal tester, voltage meter. Included, among others set of nozzles and wires for the power supply

ISP NU-LINK programmer

KT30 multimeter from Kemot with 3 1/2 digits display. The multimeter enables measurement of: DC and AC voltage up to 500 V, current up to 10 A, resistance up to 20 MΩ. Diode, transistor and circuit continuity tester

The RGB LED ruler has 8 programmable LEDs WS2812B with a built-in control system. It is possible to set a specific color for each diode. The module has an IN input for controlling and an OUT output to which further light points or other modules from WS2812B can be connected. The supply voltage is from 3.5 to 5.3 V, and the input voltage +/- 0.5 V of the supply voltage

Cable with USB type A and lightning connectors, cable length 3m. Lanberg CA-USLM-10CU-0030-WH

Module cooperating with Arduino Ethernet Shield 2 and Arduino Ethernet. It allows you to connect power to Arduino from an Ethernet network. Compliant with the IEEE 802.3af Power-over-Ethernet standard.

ZL8ARM (dipARM_2106P) - DIP module with LPC2106 microcontroller and IAP programmer

TELEPHONE REGISTRATOR WITH CLIP DECODER - PROGRAMMED SYSTEM