- Out-of-Stock
DIGITAL FILTER - PLATE AND PROGRAMMED SYSTEM
The project was created as an element of a laboratory amplifier. The regulated (and measured) voltage is read on the three-digit LED indicator field. The voltmeter was designed based on the PIC series microprocessor. The whole has a small size and is extremely compact.
The device is especially recommended as a component of the laboratory power supply
Selected parameters:
Manufacturer AVT SPV Sp. z o.o. Leszczynowa 11 03-197 Warszawa Poland zamowienia@avt.pl
Responsible person AVT SPV Sp. z o.o. Leszczynowa 11 03-197 Warszawa Poland zamowienia@avt.pl
No product available!
No product available!
This compact, inexpensive plastic gearmotor (high-power brushed DC motor with a 120:1 reduction gearbox) is well suited for use in small robots. While intended for operation at 4.5 V, it should run comfortably in the 3 V to 6 V range.
No product available!
2-pin ARK mounting strip, 5.0 mm pitch. 301-5.0-03P-12-00A(H)-BC
No product available!
No product available!
LCD touch screen with 160x128 pixel resolution, LCD160CR (I2C or UART and SPI) display controller. Adafruit 3498
No product available!
No product available!
No product available!
No product available!
No product available!
Infrared sensor that allows measurement of distances up to 15cm, has a built-in infrared illuminator, IR receiver and a perimeter of the received signal
No product available!
Development kit with Xilinx Spartan 3A FPGA. Equipped with a display, buttons, audio and video output and a microSD slot. Numato Lab FPGAX0006
No product available!
No product available!
Module with a sensor for measuring the heart rate PAH8001EI-2G. The board is equipped with a Grove connector and communicates via a digital interface. Seeed Studio 101020082
No product available!
A minisumo robot on a tracked chassis with Pololu 75:1 HP motors. Fully assembled robot, additionally requires four AA batteries. Pololu 3126
No product available!
No product available!
DIGITAL FILTER - PLATE AND PROGRAMMED SYSTEM