- Out-of-Stock
ESP-10 - WiFi module with ESP8266 without antenna
ID: 559418
WiFi 802.11 b / g / n module with ESP8266 system, 5 leads are available with 2 mm pitch with the possibility of soldering of gold pins, power lines, reset line and UART interface have been led to the connector. 3.3V power supply
Description
Wi-Fi module based on the ESP8266 system - simplicity of use (communication through UART, supports AT commands), 3.3V power supply, support for WPA / WPA2 encryption - these features make the EPS8266 module applicable anywhere, where reliable and effective data transmission. The module is not equipped with an antenna, it should be attached as shown in the picture, the length of the wire should be 6.24cm.
The module operates in the 802.11 b/g/n standard (2.4 GHz).
Features
- Supply voltage: 3.3V
- Power consumption: 300mA
- He works in WiFi 802.11 b/g/n standards
- 2.4 GHz frequency
- Works in Access Point, Standalone and combined mode (AP + STA)
- Supports LwIP
- Controlled by AT commands using UART
- Built-in antenna
- Supports WPA / WPA2 security
- Goldpin connectors 1x5 with 2 mm pitch
- Dimensions: 10x15 mm
Attention!
The bus operates at 3.3V
The bus operates at 3.3V
559418
Data sheet
- Logic voltage
- 3,3 V
- Wi-Fi chip
- ESP8266
- Wi-Fi standard
- 802.11 b/g/n
- Frequency range
- 2,4 GHz
- Baud rate
- 72,2 Mbps
- Antenna connector
- Brak
- Power supply voltage
- 3,3 V
Manufacturer BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
Responsible person BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
You might also like
WiFI 802.11 b/g/n module. Equipment includes, among others: LED diode, antenna, 8 pins with 2.54mm pitch (including 3 GPIO lines). Power supply: 3.3V.
zł10.41
24h
Available quantity: 20
Available
WiFi 802.11 b/g/n module with ESP8266 system, 16 terminals are available with a 2 mm pitch with the possibility of soldering gold pins, there are 9 GPIO lines and 1 ADC line on the connector. Built-in ceramic antenna and U.FL antenna connector. ESP-07
zł11.50
24h
Available quantity: 71
Available
WiFi 802.11 b/g/n module with ESP8266 system, they have 22 edge terminals with 2 mm raster with the possibility of soldered gold connectors, 9 GPIO lines and 1 ADC line on the connector. Built-in PCB antenna. ESP-12E
zł9.25
24h
Available quantity: 192
Available
Other products in the same category (16)
No product available!
No product available!
No product available!
Set ZL29ARM + module ZL3ETH + programmer ZL30PRGv2 + book STM32 microcontrollers in Ethernet network in examples
Delivery date unknown
No product available!
Graphic display 240x128 pixels, 144x104mm, LED backlight (WHITE) POSITIVE, T6963C / SAP1024B controller, built-in character generator
Retired
No product available!
The Counter is a stylised educational model, an interactive study guide to the mechanism, only for learning its essentials and principles of working. It registers repetitive actions. It is an integral part of a device called an “Odometer”. The model has three cylinder gears with numbers from 0 to 9 and a Geneva Drive. UGears 70130
Retired
No product available!
No product available!
No product available!
No product available!
No product available!
Brass heat sink with RPi logo for Raspberry Pi 4 model B minicomputers. Equipped with self-adhesive tape for easy installation
Retired
No product available!
No product available!
BleBox DoorBox PRO is a universal controller for gates and doors, ensuring a high level of security and remote control from anywhere in the world. Ble Box DoorBox PRO
Retired
No product available!
HK Turnigy nano-tech 1800mah 3S 65~130C Lipo Pack (19120)
Retired
No product available!
Pre-installed Android 4.x or latest version. eMMC Version 5.0 interface or higher version from Samsung.
JEDEC/MMCA version 5.0 : HS400 interface with 8bit DDR mode
Retired
No product available!
Flora NeoPixel 30 RGB LED Strip in Reel - White Backing, 5 meters. Adafruit 1376
Retired
No product available!
WiFi 802.11 b / g / n module with ESP8266 system, 5 leads are available with 2 mm pitch with the possibility of soldering of gold pins, power lines, reset line and UART interface have been led to the connector. 3.3V power supply