- Out-of-Stock
M5Stack DC MOTOR - 4-channel DC motor driver module
ID: 582023
The 4-channel DC motor driver module is designed to work with the M5Stack sets. Powered with the voltage from 6 to 12 V, it can support encoders. M5Stack DC MOTOR
Description
M5Stack DC MOTOR is a 4-channel DC motor driver module designed to work with M5Stack sets. There are two 2-channel L293DD controllers on the board, which are connected to the ATmega328 microcontroller and a Step Down converter with an output voltage of 5 V, which supplies not only the logic part of the module, but also the M5Stack evaluation kit. There are 4 6-pin connectors with encoder support for motors. The module is supplied with the voltage ranging from 6 to 12 V through the XT30 connector. In addition, the board has two Grove connectors with an I2C interface for connecting additional sensors and display. The module can cooperate with with Pololu drives or motors from the LEGO EV3 series. Full documentation is available on the product page.
Features
- ATmegs328 microcontroller
- 4 channels
- 2 x L293DD chip
- 4 x 6-pin motor connector
- 2 x I2C Grove connector
- Step Down 5V converter
- Compatible with LEGO motors
- Power supply: 6 to 12 V
- Dimensions: 54 x 54 x 12 mm
- Weight: 17 g
Kit contains
- M5Stack DC MOTOR module
- 10 cm motor cable
- XT30 adapter
582023
Manufacturer BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
Responsible person BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
You might also like
M5Stack series development kit equipped with WiFi and Bluetooth ESP32 module. It will work in IoT-related projects, as a STEM educational module or in Smart Home devices. M5Stack K010
zł249.00
24h
Available quantity: 2
Available
M5Stack series development kit equipped with ESP32. It will work in IoT-related projects, as a STEM educational module or in Smart Home devices. M5Stack K001-V26
zł264.91
24h
Available quantity: 1
Available
Other products in the same category (16)
No product available!
No product available!
No product available!
No product available!
This is an aluminum heat-sink for the Banana Pi RAM Chips. Run cool RAM chips with this little add-on. Just one heat-sink is needed to cover both RAM chips, use the picture below as reference. Signs of RAM or CPU overheating are computer stops responding, frozen screen and power shutt down or cycling.
Retired
No product available!
No product available!
Spring dedicated to the heating table of 3D printers. It allows you to adjust the degree of tightening the knob, and thus enables the proper leveling of the working table
Retired
No product available!
No product available!
No product available!
No product available!
No product available!
Mini analog servo with plastic gear. It has a range of motion of 180°. Pololu 1046
Retired
No product available!
A pre-installed radio for everyone. AVT5540 C
Retired
No product available!
No product available!
Assembled power amp with LCD display. AVT3218 C
Retired
No product available!
A set with two IMX219 cameras with a resolution of 8 MP and an expansion module for the Raspberry Pi, which allows you to connect two cameras simultaneously. ArduCAM B0350
Retired
No product available!
The 4-channel DC motor driver module is designed to work with the M5Stack sets. Powered with the voltage from 6 to 12 V, it can support encoders. M5Stack DC MOTOR