Pololu 2118 - Pololu Adjustable Step-Up/Step-Down Voltage Regulator S7V8A
search
  • Pololu 2118 - Pololu Adjustable Step-Up/Step-Down Voltage Regulator S7V8A
ID: 208826
5906623468768
zł37.23
Tax included

zł30.27 tax excl.

The Step-Up/Step-DownS7V8A Buck Voltage Regulator module with adjustable output voltage in range of 2.5-8V, input voltage range of 2.7-11.8V and a maximum output current of 0.5-1A. Pololu 2118

24h
Available
Available quantity: 3
Pololu 1A converters S7V8, voltage:
2,7-11,8 / 2,5-8 V
2,7-11,8 / 5 V
Kamami is the official distributor of electronic modules and Pololu robotic parts. All products of this brand in our offer are original and come directly from the manufacturer.

Description

The Step-Up/Step-DownS7V8A buck voltage regulator module with adjustable output voltage in range of 2.5-8V and input voltage range of 2.7-11.8V. The maximum current load of the module depends of input and output voltage and is in range of 0.5-1A. The converter achieves a standard efficiency of above 90% at similar values of input and output voltage.

Note! The board does not have reverse-voltage protection. Incorrect power connection will cause permanent damage of the module.

Features

  • Input voltage: 2.7-11.8 V
  • Output voltage in range of 2.5-11.8V
  • Type. maximum current: 0.5-1A
  • Built-in protection against short-circuit and overheating
  • Type. efficiency: 90%
  • Size: 11 × 17 × 3 mm
  • Possibility of mounting goldpin

Connections

  • VIN - power input (2.7-11.8V)
  • GND - mass
  • VOUT – output
  • SHDN pin can be driven low (under 0.4 V) to power down the regulator and put it in a low-power state. The quiescent current in this sleep mode is dominated by the current in the 100k pull-up resistor from SHDN to VIN. With SHDN held low, this resistor will draw 10 µA per volt on VIN (for example, the sleep current with a 5 V input will be 50 µA). The SHDN pin can be driven high (above 1.2 V) to enable the board, or it can be connected to VIN or left disconnected if you want to leave the board permanently enabled

Kit contains

  • Buck converter module S7V8A x1
  • Goldpin connector 4pin straight x1
  • Goldpin connector 4pin right-angle x1
208826

Data sheet

Output voltage
2,5 - 8 V
Output current
1A
Converter type
Step-down/step-up
Supply voltage min
2,7 V
Supply voltages max
11,8 V

Manufacturer

  • BTC Korporacja sp. z o. o.
  • Ludwinowo Zegrzyńskie 52G
  • 05-140 Ludwinowo Zegrzyńskie
  • Poland
  • [email protected]
  • 22 767 36 20

Responsible person

  • BTC Korporacja sp. z o. o.
  • Ludwinowo Zegrzyńskie 52G
  • 05-140 Ludwinowo Zegrzyńskie
  • Poland
  • [email protected]
  • 22 767 36 20

Other products in the same category (16)