Category: STARTER KITS, PROGRAMMERS, MODULES

Module with temperature sensor MCP9808. The board is equipped with a Grove connector and communicates via the I2C interface. Seeed Studio 101020556

A module with a high precision temperature sensor based on the MCP9808 chip. Equipped with a STEMMA QT connector, it communicates via the I2C interface. Adafruit 5027

The module with the buffer of the I2C bus based on the TCA4307 system. It allows you to connect I2C devices with active power supply. Equipped with a STEMMA QT connector. Adafruit 5159

Module with a 16-channel GPIO expander with the ability to control LEDs. Equipped with a STEMMA QT connector, it communicates via the I2C interface. Adafruit 4886

Air quality sensor module based on SGP30 system. The board has been equipped with Qwiic connectors. SparkFun SEN-16531

Module with a 10-channel AS7341 sensor that detects light in various wavelength ranges (color detection). It communicates via the I2C interface. Adafruit 4698

Module with 9-axis IMU sensor BNO055. It has a built-in processing chip that returns orientation in 3D space. Communicates via I2C. Adafruit 4646

Module with temperature and humidity sensor DHT11. It allows you to measure humidity in the range of 20 ... 90% and temperature (0 ... 50 ° C). DFRobot DFR0067

Module with a button, LED diode and a red cap. DFRobot DFR0029-R

The module allows the detection of volatile organic compounds (VOC) in the air, based on Winsen\'s WSP2110 system. Allows for detection in the air; formaldehyde (HCHO), methane, benzene, toluene, alcohol, etc. The sensor output is an analog signal. Seeed studio 101020001

The P-NUCLEO-53L1A1 is a complete evaluation kit allowing anyone to learn, evaluate, and develop their application using the VL53L1X ToF, long-distance ranging sensor technology

Adapter dedicated to the Nintendo Wii Nunchuck. It allows you to connect the controller to the development board via the I2C interface. Adafruit 4836

Module with a logarithmic digital potentiometer based on the DS1841 chip. Equipped with a STEMMA QT connector, it communicates via the I2C interface. Adafruit 4570

Clock signal generator with a frequency of 8 kHz to 160 MHz based on the SI5351A integrated circuit. Communication with the module takes place via the I2C bus. Adafruit 5640

Module with the OPTIGA TRUST M SLS32AIA cryptographic chip. Equipped with a STEMMA QT connector, it communicates via the I2C interface. Adafruit 4351

Universal EEPROM and Flash serial memory programmer. It is controlled from the computer via the USB interface and software for Windows systems. CH341

The board with the RP2040 microcontroller equipped with two ARM Cortex-M0 + cores operating at 133 MHz, 256 kB RAM. The board also has 16 MB of QSPI flash memory. The system can be programmed in C/C++ or microPython. SparkFun DEV-18288

The magic:bit expansion module is designed to work with the micro:bit learning board. It can control servos, DC motors, stepper motors, has four RGB LEDs, an IR receiver and a buzzer

WiFi module based on ESP8266. It has an embedded antenna and 0.96 "OLED display. The module can be programmed in Lua (under NodeMCU firmware control) or in the Arduino IDE. Provides 12 GPIO lines.

I2C 8-channel expander module. The board is equipped with a Grove connector and communicates via the I2C interface. Seeed Studio 103020293