Arducam USB shield is a module that allows you to connect some ArduCam cameras to a PC or minicomputers, eg Raspberry Pi, BeagleBone etc. The module supports most cameras with a serial interface that have a resolution of 0.3 ... 14 MPix. Attached to the module are appropriate libraries that facilitate image processing, eg using OpenCV software. ArduCam B0095

TFT LCD display with a diagonal of 3.5" and a resolution of 480x320 pixels. Equipped with a resistive touch panel and a microSD slot. Intended for use with Feather series boards. Adafruit 3651

Industrial grade USB-UART TTL converter. Equipped with a number of security features ensuring stable and safe communication. Waveshare USB TO TTL (B)

Module with ToF VL53L4CD sensor with a range of up to 1.3 m and a resolution of 1 mm. It is equipped with a Qwiic connector and communicates via the I2C interface. SparkFun SEN-18993

Step-Up/Step-Down converter module based on the S13V20F5 system. It has an input voltage from 2.8 to 22 V and an output voltage of 5 V. The current efficiency of the converter is up to 2,5 A. Pololu 4085

Module with black and white 10-digit LCD display. Equipped with a STEMMA QT connector, it communicates via the I2C interface. Adafruit 5379

RGB LED matrix display with a resolution of 64 x 64 (4096 LED). Adafruit 5362

A set for building a weather station equipped with a rainfall sensor and a wind speed and direction meter. SparkFun SEN-15901

Module with a 7-color ACeP e-Paper display with a diagonal of 5.7" and a resolution of 600 × 448 px. It communicates via the SPI interface. Pimoroni PIM609

Dual DC motor controller designed for Arduino, which enables the motor to be supplied with voltage in the 4.5 ... 28V range and power consumption in continuous operation of 2.6 A (5A at the top) of two DC motors. Polol 2520

Set of 10 cables, 50 cm long, for digital sensors compliant with the Gravity standard. DFRobot FIT0756

This breakout board, the ultimate companion for the VLSI VS1053B DSP codec chip, can decode a wide variety of audio formats MP3, AAC, Ogg Vorbis, WMA, MIDI, FLAC, WAV (PCM and ADPCM); it can be used to record audio in both PCM (WAV) and compressed Ogg Vorbis. 8 GPIO pins can be used for lighting up small LEDs or reading buttons. Adafruit 1381

A set of test leads 2x4 (4 signal and 4 GND) with a length of 23cm and 22AWG intended for logic analyzers Saleae.

BOB-11890

A module with a temperature and humidity sensor based on the AHT20 system. Equipped with a STEMMA QT connector, it communicates via the I2C interface. Adafruit 4566

A set of 8 test clips for Saleae logic analyzers. Saleae Test Clips 8-Pack

Module with BME680 for measuring the concentration of VOC, pressure, temperature and humidity. Equipped with a STEMMA QT connector, it communicates via I2C or SPI. Adafruit 3660

Module with an RFID tag based on the ST25DV16K chip. It can be reprogrammed via the I2C bus. Equipped with STEMMA QT connector and PCB antenna. Adafruit 4701

Module with a 3-axis magnetic field sensor LIS3MDL. Equipped with a STEMMA QT connector, it communicates via the I2C interface. Adafruit 4479