Category: Grove peripheral modules (Seeed Studio)

intelligent gesture recognition module equipped with an IR camera module PAG7646J1, PAG7661QN (ISP) and a LED for backlighting. Recognizes and interprets hand gestures by recognizing the image recorded by an infrared camera. Seeed Studio 101991067

Module with a passive buzzer. The board is equipped with a Grove connector and is controlled by a PWM signal. Seeed Studio 107020109

Module with SPDT switch. The board is equipped with a Grove connector and communicates via a digital interface. Seeed Studio 101020004

Module with replaceable LED diodes in 4 colors: red, green, blue and white. The board is equipped with a Grove connector and communicates via a digital interface. Seeed Studio 104020228

Module allowing collision / vibration detection (based on the MVS0608.02 system). Permitted to detect collisions irrespective of direction, provides high stability and is highly sensitive. The module has a connector in accordance with the Grove standard. Seeed studio 101020005

Module with a TDS sensor that allows you to measure the total content of solids dissolved in water. The board is equipped with a Grove connector and communicates via an analog interface. Seeed Studio 101020753

Module with 20 RGB LEDs WS2813 Mini. The board is equipped with a Grove connector and communicates via a digital interface. Seeed Studio 104020170

Module with 15 RGB LEDs WS2813 Mini. The board is equipped with a Grove connector and communicates via a digital interface. Seeed Studio 104020172

Recorder v3.0 is a module that allows you to record and play sounds. The module was based on the ISD9160FI system, it also has a FLASH memory with a capacity of 2 MB, which allows for recording up to 83 seconds long. The set contains a small loudspeaker on which recorded sounds can be played. Seeed studio 107020029

Module with a magnetic sensor based on the CT10 reed switch. CT10 is a unipolar reed switch, normally open. The sensor reacts to the action of an electromagnet, permanent magnet or a combination thereof. The module has a connector in accordance with the Grove standard. Seeedstudio 101020038

The Hall sensor module allows magnetic field detection, can be used to measure angle of rotation, displacement, mechanical vibrations, etc. The module has a connector in accordance with the Grove standard. Seeed studio 101020046

Module with a flame sensor or other light sources with a wavelength in the range of 760 to 1100 nm. It was based on the YG1006 sensor (photovolver NPN). The sensor has a connector compatible with the Grove standard. Seeed studio 101020049

Air530Z GPS module with external antenna. The board is equipped with a Grove connector and communicates via the UART interface. Seeed Studio 109020022

Module with a slide potentiometer. Depending on the position of the slider, the resistance value (maximum resistance 10kΩ) changes, which translates into the voltage value at the analog output of the module. The module has a connector in accordance with the Grove standard. Seeed studio 101020036

Module with RGB LED, it is possible to control individual colors using digital signals as well as PWM signals. The module has a connector in accordance with the Grove standard. Seeed studio 101020472

Module with temperature and humidity sensor DHT11. The board is equipped with a Grove connector and communicates via a digital interface. Seeed Studio 101020011

Module with red LED diode and potentiometer. The board is equipped with a Grove connector and communicates via a digital interface. Seeed Studio 104030005

Module with LCD display 16x2 characters with RGB backlight. The board is equipped with a Grove connector and communicates via I2C. Seeed Studio 104030001

Module with LM386 audio amplifier and loudspeaker. The board is equipped with a Grove connector and is controlled by a PWM signal. Seeed Studio 107020001

Module with an EMG signal detector. The board is equipped with a Grove connector and has an analog output. Seeed Studio 101020058