- Out-of-Stock
Cooling Fan XU4 Blue
ID: 562769
5906623437160
- The ODROID-XU4 includes the cooling fan by default. You might need this part when you want to replace the original cooling fan
Description
The ODROID-XU4 includes the cooling fan by default. You might need this part when you want to replace the original cooling fan.
Features
- Power : 5Volt / 120mA(max)
- Dimension : 39.5 x 40.0 x 10.0 mm
- Fan speed : 4000rpm approx.
- Cable length : 50mm approx.
- Noise Level : 23dBA approx.
- Blue anodizing surface
Note: Package includes a thermal paste tube. The thermal paste is responsible for conducting heat from the processor to the heat sink. Reassembling without applying thermal paste will cause the processor to overheat.
PWM port on ODROID-XU4 2pin header which connector is Molex 51021-0200 / 1.25mm pitch.
The fan motor speed is controlled by CPU temperature proportionally. Thermal interface material (double-side tape) is assembled.
Installation Guide:
- Step 1 : Remove the stock cooling fan
- Step 2 : Clear the surface of the CPU and cooling fan
- Step 3 : Apply the thermal paste on the CPU surface. Make sure to cover the entire surface that will mate to the cooler.
- Step 4 : Install the new cooling fan
Cautions! Minimize stress/bending to the PCB when you mount/un-mount the cooler
562769
Data sheet
- Voltage
- 5 V
- Power
- 0,6 W
- Length
- 39,5 mm
- Width
- 40mm
- Height
- 10
- Weight
- Other
- Noise level
- 23 dBA
- Air flow efficiency
- Other
- Rated current
- 120 mA
- Fan type
- Axial
Manufacturer BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
Responsible person BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
Other products in the same category (16)
Permanent cylindrical neodymium magnet with a diameter of 12 mm and a height of 2 mm.
Retired
No product available!
No product available!
No product available!
No product available!
No product available!
No product available!
Gravity: GPIO Shield for Arduino is an I / O port expander compatible with Arduino UNO. It allows to expand the capabilities of the base board by providing a total of 36 digital and analogue pins as well as UART and I2C interfaces. DFRobot DFR0334
Retired
No product available!
No product available!
REMOTE CONTROLLED MODULE I / O WITH THE ACCESS CODE - PLATE AND PROGRAMMED SYSTEM
Retired
No product available!
No product available!
This in-system programmer can be used to program AVR microcontrollers and AVR-based controller boards, such as our Orangutan robot controllers and the 3pi robot. Pololu 3170
Retired
No product available!
No product available!
No product available!
No product available!
Franz Hlawatsch, Gerald Matz
Delivery date unknown
No product available!
The Arduino GSM Shield connects your Arduino to the internet using the GPRS wireless network. Just plug this module onto your Arduino board, plug in a SIM card from an operator offering GPRS coverage and follow a few simple instructions. You can also make/receive voice calls (you will need an external speaker and microphone circuit) and send/receive SMS messages.
Retired
No product available!
- The ODROID-XU4 includes the cooling fan by default. You might need this part when you want to replace the original cooling fan