XH-M802 - Audio preamplifier module

The board has a class D amplifier onboard that can drive 2 channels of 4-8 ohm impedance speakers at 20W each. Adafruit 1752

Class D mono digital audio amplifier module PAM8302. The system allows you to connect one loudspeaker with an impedance from 4 to 8 Ω and a power of 2.5 W

HiFi stereo tube amplifier based on 6J1 and 6P1 tubes. Designed for use with loudspeakers up to 3 W and an impedance of 4 Ω or 8 Ω

Audio amplifier module with three output channels. It can be powered with the voltage from 18 to 24 VAC and has two outputs with a power of 100 W (left and right) and one with a power of 120 W (bass)

Class D digital audio amplifier with Bluetooth 5.0 module. It has two channels with a power of 50 W and can work with speakers from 2 to 8 Ω. Powered with DC voltage from 12 to 24 V. Fosi Audio BT20A

Zeenko ZK09-BM is a low-noise, ultra-wideband RF amplifier with an operating range up to 10 GHz, powered by a built-in battery. Thanks to its good linearity and noise performance, it is used in measurements, receiver paths and communication systems. Compact and mobile, it will work well both in laboratories and in the field.

The XH-A902 preamplifier module with the NE5532 chip provides a fivefold increase in sound power, operating in the voltage range of 12-30V. Using the renowned NE5532 chip, it offers excellent amplification in two channels,

WM8960 stereo codec module with driver for 1W class D speakers and headphones. It uses the I2S interface and the I2C bus to configure the system. SparkFun BOB-21772

Stereo audio amplifier with Bluetooth 5.0 communication. It can be powered with the voltage from 9 to 24 V and has two outputs with a power of 50 W. Assembly kit. ZK-502C

Class D digital audio amplifier with Bluetooth module. It has two channels with a power of 50 W and can work with speakers from 4 to 8 Ω. It is powered with the voltage in the range from 9 to 24 V. NS-01G

Class D digital audio amplifier. It has two channels with a power of 160 W and can work with speakers from 4 to 8 Ω. It is powered with the voltage from 15 to 36 V.

The module with digital stereo audio amplifier is equipped. The system allows you to connect two speakers with an impedance from 4 Ω to 8 Ω and a power of 15 W

4-channel stereo audio mixer in a metal housing. It has one output, on which the summed signal from 4 inputs is available. It is powered with the voltage from 5 to 12 V.

Module with two operational amplifiers OPA627

A sound card in the form of a small device with a USB plug, designed to work with the Raspberry Pi and NVIDIA Jetson Nano minicomputer. Waveshare USB TO AUDIO

LM386 mono digital audio amplifier module. The system allows you to connect a loudspeaker with a power of up to 10 W. Kit for self-assembly