Best sellers

RGB LED matrix display with 13x9 LEDs. Equipped with IS31FL3741 driver and two STEMMA QT connectors. Adafruit 5201

Controller of three-phase BLDC motors based on Trinamic\'s TMC6300 chip. Allows motion control of drives with a current consumption of up to 2 A. SparkFun ROB-21220

Camera set with IMX477 sensor with 12 MPx matrix, allows for remote camera rotation, tilt angle and zoom control. Works with Raspberry Pi minicomputers. Swivel base included. ArduCAM B0167B12

A base board dedicated to Raspberry Pi CM4 modules. It is equipped with two RJ45 connectors, USB 2.0 and a microSD slot. In addition, there is a fan connector on the board. Waveshare CM4-DUAL-ETH-MINI-BOX (EU)

A small WiFi module designed for IoT applications. It can communicate with the motherboard via the I2C or UART interface. DFRobot TEL126

Small metal gear motor, 60 RPM speed, 3V operating voltage. GA12-N20-0004

A set for building a walking robot. The chassis is equipped with four servos, a controller and an STM32F030 microcontroller. M5Stack U086

Portable Flash programmer for built-in and external flash memory. Segger Flasher Portable PLUS

Gravity module with a colored RGB WS2812 LED. Thanks to the controller built into the diode, you can connect the modules in series and control all with one microcontroller port. DFRobot DFR0605

E-ink display for Raspberry Pi with 2.13 "diagonal resolution and 250x122 pixels with SPI controller. DFRobot DFR0591

5-port USB 3.0 Hub with controls and switches for each port. The set includes a 12 V power supply with a capacity of 2 A

Single board computer with SOM module NXP i.MX 8M processor, has 1 GB of RAM, 8GB of eMMC memory, wireless communication and TPU coprocessor. It includes numerous connectors, including USB 2.0 / 3.0 ports, DSI interface, CSI-2, Ethernet port, audio connectors and a 40-pin GPIO connector. Coral Dev Board G950-01455-01

3mm white LED. 1000 pieces in the package

3mm orange LED. 1000 pieces in the package

Module with rain sensor. It allows you to detect precipitation using the analog output

Case for Arduino Mega2560, closed, with access to connectors, black

ACeP e-Paper 7-color display with a diagonal of 5.65" and a resolution of 600×448 px. SPI interface. Without PCB. Waveshare 5.65inch e-Paper (F)

Set of M.2 connectors for MicoMod modules. Necessary when designing your own expansion board. SparkFun KIT-16549

RC extension cable dedicated to servos, comes with JR/Futaba female and male connectors. It has twisted wires