Best sellers

GY-9250 is a 9 Degrees of Freedom (9DoF) module with the InvenSense MPU-9250 chip. It has a built-in gyroscope, accelerometer and magnetometer.

32-bit STM32F2 microcontroller with ARM Cortex-M3 core, 1MB Flash memory, 132kB RAM, 120MHz, CAN, Ethernet, I2C, IrDA, LIN, Memory Card, SPI, UART / USART, USB OTG, Brown-out Detect / Reset, DMA, I2S, LCD, POR, PWM, WDT, 1.8 ... 3.6 V, A / D 24x12b; D / A 2x12b, 100-LQFP

The compact (0.4″ × 0.5″) D24V5F9 synchronous buck voltage regulator takes an input voltage of up to 36 V and efficiently reduces it to 9 V while allowing for a maximum output current of 500 mA. Pololu 2845

Hybrid bipolar stepping motor with integrated 38cm (15″) threaded rod as its output shaft, turning it into a linear actuator capable of precision open-loop positioning. The motor has a 1.8° step angle (200 steps/revolution) and each phase draws 1.7A at 2.8V, allowing for a holding torque of 3.7kg-cm (51 oz-in). Pololu 2690

The Pololu A-Star 32U4 Prime is a general-purpose programmable board based on Atmel’s ATmega32U4 AVR microcontroller and arranged in the common Arduino form factor exemplified by the Uno R3 and Leonardo. Pololu 3114

This small synchronous switching step-down (or buck) regulator takes an input voltage of up to 38 V and efficiently reduces it to 9 V. The board measures only 0.7″ × 0.7″, but it allows a typical continuous output current of up to 2.5 A. Typical efficiencies of 85% to 95% make this regulator well suited for powering moderate loads like sensors or small motors.

Arduino Starter Kit with Uno board

Dual Full-Bridge Driver, Power SO20, STM, RoHS

The module allows measuring the light around the sensor. The measuring range is in the range 1 - 65535 LUX, and communication takes place using the I2C bus. modBH1750 (GY-302)

modTSL2561 is a module containing a light sensor TSL2561; communication with the system takes place using the I2C bus

Accelerometer and gyroscope module, allows measurement of acceleration in the range of +/- 16 G and angular velocity in the range up to +/- 2000 dps. modMPU6500 (GY-6500)

GY-346 is a module with a digital acceleration sensor (accelerometer) ADXL346; communication on the I2C / SPI bus

A set of 100 pieces of various colored heat-shrinkable tubing for wire insulation, 10 cm long. NAR0832

A 30/130 W pistol soldering iron with a ceramic heater provides fast heating and precise temperature control, enabling effective soldering of electronic components. Intended for workshop and hobby use, it performs excellently in service and assembly work.

PCB connector, 5-pin, 1-row pitch, 1.25 mm, 1 A PICOBLADE, Molex 53047-0510

Digital panel meter with red LED display; allows you to measure DC voltage up to 100V and measure current up to 10A. The meter can be supplied with voltage from the range of 3.5-30 V DC and is equipped with wires with a length of 14 cm. Panel Meter DC100V / 10A

Linear potentiometer with force sensor. It has an analog output, it allows you to detect where and with what force the sensor strip has been pressed. Pololu 2729

36 V 400 mA synchronous step-down switching regulator, VFDFPN10, STM, RoHS

Magnetic Displacement Sensors, SOIC8, Honeywell Microelectronics & Precision Sensors, RoHS

ARM®-based 32-bit MCU, 128 KB Flash, CAN, 12 timers, ADC, DAC & comm. interfaces, 2.0 - 3.6V, LQFP100, STM, RoHS