Best sellers
There are 17479 products.
The Step-Up Buck Voltage Regulator module with adjustable output voltage in range of 2.5-9.5V with a input voltage range of 1.5-16V and a maximum output current of 2A. Pololu 791
The module with 4 relays is designed to work with Arduino. It allows you to control devices with operating parameters up to 250VAC/7A or 30VDC/10A. Seeed Studio 103030009
Module with DHT20 sensor. It allows you to measure humidity in the range from 0 to 100% and temperature from -40 to 80 ℃. Seeed Studio 101020932
Bipolar stepper motor. It has a resolution of 200 steps/revolution (1.8 ° per step), has a nominal voltage of 7.4 V, and draws a current of 0.28 A per coil. Pololu 1207
A4988 Stepper Motor Driver Carrier
Module with four gas sensors that allow the detection of CO, NO2, alcohol and volatile organic compounds (VOC). The board is equipped with a Grove connector and communicates via the I2C interface. Seeed Studio 101020820
Module for recording sounds, which can store recordings up to 20 seconds. The board is equipped with a Grove connector and communicates via a digital interface. Seeed Studio 107020007
Air530Z GPS module with external antenna. The board is equipped with a Grove connector and communicates via the UART interface. Seeed Studio 109020022
LM386 audio amplifier module in a set with a loudspeaker. The board is equipped with a Grove connector and is controlled by a PWM signal. Seeed Studio 101020853
Active HDTV antenna with 28 dB amplification, supporting FullHD and 4K UltraHD standard. Designed for indoor installation. BLOW ATD40
7-inch touch display with an IPS panel and DSI connector enclosed in a white polycarbonate protective housing intended for Raspberry Pi 4B. It provides high image quality and precise touch control, serving as a functional user interface in embedded applications and visualization systems.
Doppler radar module with 24GHz BGT24LTR11 transceiver. The board is equipped with a Grove connector and communicates via the UART interface. Seeed Studio 109020021
Board with digital outputs designed to work with STM32 Nucleo. It is based on the IPS1025H-32 single high-side switch circuit. STMicroelectronics X-NUCLEO-OUT06A1
Decoder dedicated to receive digital terrestrial TV programs in the DVB-T2 H.265 standard. Designed for TVs with HDMI, USB, SCART and RF input. BLOW 4625FHD
The NFC module kit based on the ST25R3911B chip and the STM32F103RBT6 microcontroller enables wireless transfer of graphics from a microSD card to Waveshare e-Paper displays with NFC. Equipped with a 1.3" OLED display, a CP2102 USB-UART converter, 1 Mbit SRAM memory and user interfaces, it supports rapid prototyping of NFC applications and wireless communication systems. Waveshare 17623
Module with a pulse sensor and the level of SpO2 (oxygen saturation level). It is based on the MAX30102 chip and communicates via the I2C or UART interface (Gravity connector). DFRobot SEN0518
2-channel USB-CAN adapter with CAN protocol analyzer function. Dedicated to industrial applications. Waveshare USB-CAN-B
Machine Screw: #2-56, 7/16" Length, Phillips (25-pack)
Toggle switch, two-position with cover and LED illumination. It can switch voltage up to 12 V and current up to 20 A