Best sellers
There are 16521 products.
Module with a black and white OLED display 1.3" with a resolution of 128x64 pixels. Designed for M5Stack sets. It communicates via the I2C interface. M5Stack U119
QUICK Q303-3C soldering tip with sensor for: Quick 202D
A set for building an interactive robot based on the micro: bit module. It can be programmed using tools such as Mind+, Scratch, MakeCode and MicroPython. DFRobot MBT0021-EN
RC extension cable dedicated to servos, comes with JR/Futaba female and male connectors
ireless sensor with LoRaWAN network communication. Dedicated to industrial long-distance data acquisition with a wide light intensity measurement range from 0 to 160000 Lux. Seeed Studio 114992868
A small WiFi module designed for IoT applications. It can communicate with the motherboard via the I2C or UART interface. DFRobot TEL126
The module with 6 capacitive touch buttons and LED diodes, designed to work with the Raspberry Pi. The buttons are connected to the minicomputer via the CAP1166 controller, which communicates via the I2C interface. Pimoroni PIM272
Large momentary button with a diameter of 100 mm with LED backlight. It was based on a limit switch. The housing is black
Probe for measuring AC currents up to 1000 A. It works in the range from 10 Hz to 100 kHz, it can be connected to the oscilloscope through the BNC connector. Micsig ACP1000
Module with 4-channel ADC ADS1015 converter. The system enables analog voltage conversion for single signals and differential signals with 12-bit resolution. I2C communication
Self-assembly case designed for minicomputers Odroid H3 and Odroid H3+. Equipped with a place for a fan. Hardkernel ODROID-H3 Case Type 2
Module with LCD IPS touch display with a diagonal of 2.8" and a resolution of 320x240 px. Communication via the SPI interface. Waveshare Pico-ResTouch-LCD-2.8
CS-Mount lens. 25 mm focal length, 14° FoV, manual focus. Designed to work with the Raspberry Pi HQ camera. ArduCAM LN041
Module of the 3-axis LIS2DH, I2C accelerometer. DFRobot SEN0224
Self-assembly case designed for minicomputers Odroid H3 and Odroid H3+. Equipped with a slot for a network card and two slots for a 2.5" SATA drive. Hardkernel ODROID-H3 Case Type 7
Board with prototype holes dedicated to Raspberry Pi Pico. It offers an 8x20 hole area with a pitch of 2.54 mm with marked pin labels and a reset button and STEMMA QT connector. Adafruit 5200
Module with the PIR EKMB1107112 motion sensor, the standby power consumption of up to 1 uA. SparkFun SEN-17373
E-ink display for Raspberry Pi with 2.13 "diagonal resolution and 250x122 pixels with SPI controller. DFRobot DFR0591
Module with a GPS PA1010D receiver with a built-in ceramic antenna. It can download data from the most popular navigation systems: GPS, GLONASS, GALILEO. Pimoroni PIM525