Best sellers
There are 15482 products.
Module with a 3-color e-Paper display with a diagonal of 2.66" and a resolution of 296x152 px. Communication via the SPI interface. Waveshare Pico-ePaper-2.66-B
Snap-Action Switch with 16.7mm Lever: 3-Pin, SPDT, 5A
Sensor for detecting the distance, intensity and frequency of light (lightning) within a radius of 40 km. The module enables weather enthusiasts to measure data about local storms. DFRobot SEN0290
Module with black and white e-Paper display with 2.9" diagonal. Equipped with SPI interface for image display and I2C interface for touch panel. Waveshare Pico-CapTouch-ePaper-2.9
Large heat sink in the form of a case covering the entire board. Designed for Raspberry Pi 4 minicomputers. Gray color.
7" TFT LCD display with touch screen. The display is equipped with DSI interface for image display and I2C interface for touch screen. Resolution 800x480 pixels. Waveshare 7inch DSI LCD
Multifunctional micro:bit expansion module with built-in Li-Ion battery. The board is equipped with a two-channel DC motor driver, 9 IO pins, I2C, UART interface, buzzer, 4 RGB LEDs and a charging circuit. DFRobot MBT0005
Module with MEMS microphone; model SPW2430 with built-in amplifier. The plate also has a 3.3 V voltage stabilizer needed to power the microphone. Adafruit 2716
Extension module with a breadboard designed for micro:bit. There are male and female connectors with all IO pins. A great solution for prototyping. DFRobot MBT0009
N-channel 120V 7.9mΩ standard level MOSFET in TO220, TO-220AB, NXP, RoHS
10 cm 3-pin cable with JST PH2.0 female plug to 2.54 mm 3-pin female goldpin
A set of two Pololu wheels measuring 32x7mm in white. Fits D-shaped shaft with a diameter of 3mm. Pololu 1088
Raspberry Pi Prototype HAT is a prototype board that fits Raspberry Pi3, Pi 2 and + computers. The set includes a self-assembly connector and assembly elements
LM386 audio amplifier module in a set with a loudspeaker. The board is equipped with a Grove connector and is controlled by a PWM signal. Seeed Studio 101020853
Versatile, low-cost debugger and programmer for 8-bit and 32-bit microcontrollers
At the Feather M0\'s heart is an ATSAMD21G18 ARM Cortex M0 processor, clocked at 48 MHz and at 3.3V logic, the same one used in the new Arduino Zero. This chip has a whopping 256K of FLASH (8x more than the Atmega328 or 32u4) and 32K of RAM (16x as much)! This chip comes with built in USB so it has USB-to-Serial program & debug capability built in with no need for an FTDI-like chip. Adafruit 3179
Module with 6-axis IMU sensor MPU6886, which combines a 3-axis accelerometer and a 3-axis gyroscope. M5Stack U095
The CAN transmitter and receiver module is intended for M5Stack sets. It is based on an isolated CA-IS3050G transceiver system, which can provide differential data reception and transmission. M5Stack U085