Best sellers

This BLDC motor controller, based on the Allegro A89301 chip, enables sensorless control over a wide voltage range from 5.5 V to 48 V and phase current up to 11 A without additional cooling. It supports four control modes: analog voltage, PWM signal, pulse frequency, and via an I²C interface with the ability to configure parameters and save settings to EEPROM. The Field-Oriented Control (FOC) algorithm ensures quiet and efficient operation, while built-in protection protects the system against short circuits, reverse polarity, and undervoltage. Pololu 5357

Programmable Low-Power Operational Amplifier, DIP8, Texas Instruments, RoHS

Tamiya 70171 3mm Threaded Shaft Set

Solarbotics RW2i Wheel (internal set screw)

Machine Screw: M3, 25mm Length, Phillips (25-pack)

Motor with 25 mm diameter and 54 mm length, 75:1 metal gear, 6 V operating voltage, 0,25 A to 2,4 A power consumption, 78 RPM speed and 6,8 maximum torque. Pololu 1586

Aluminum Standoff: 1-1/4" Length, 2-56 Thread, M-F (4-Pack)

Aluminum Standoff: 3/8" Length, 4-40 Thread, M-F (4-Pack)

SMA–MCX coaxial cable, 2 m long and with 50 Ω impedance, provides reliable connection in radio and measurement systems. Made of RG316 cable, it ensures low signal loss and durability thanks to gold-plated connectors.

The XT90 to XT60 adapter allows for direct connection of components with various power connector standards. It\'s ideal for robotic projects, modeling projects, and test systems where quick adaptation of the power source to a specific device without modifying the installation is essential

Nylon Spacer: 8mm Length, 4mm OD, 2.7mm ID (50-Pack)

Nylon Spacer: 15mm Length, 4mm OD, 2.7mm ID (25-Pack)

Nylon Spacer: 25mm Length, 4mm OD, 2.7mm ID (10-Pack)

This 1-meter white USB A to USB Micro-B cable is designed for powering and communicating with microUSB devices. It\'s perfect for electronics projects, mobile device servicing, and connecting development boards to a computer

The BMG extruder is a Bowden unit with dual drive, offering a 3:1 gear ratio and adjustable filament tension. It fits Ender 3, CR-10, Prusa i3, and similar printers. An ideal upgrade when better filament control is required, especially for flexible materials or with large retractions.

Ultrasonic distance sensor MB1010 with a range from 0 to 645 cm. It has an output in the form of a serial interface, analog signal or generates an impulse whose duration is proportional to the measured distance. Pololu 726

SimpleFOC Shield Type B enables precise control of BLDC motors using FOC technology, supporting supply voltages up to 35 V and working with Arduino and STM32. The module is equipped with INA240 current sensors and an IR2104 driver with configurable gate voltage, allowing precise motion control in robotics and automation projects.