- Out-of-Stock
Bare Conductive - Electric Paint Pen (10ml)
ID: 202160
Bare Conductive’s Electric Paint is just like any other water-based paint… except that it’s electrically conductive! This means that you can actually paint wires onto things like models, clothes, furniture, walls, almost anything you can think of. COM-11521
Description
Bare Conductive’s Electric Paint is just like any other water-based paint… except that it’s electrically conductive! This means that you can actually paint wires onto things like models, clothes, furniture, walls, almost anything you can think of. Standard acrylic or water-based paints can even be used alongside Electric Paint to act as insulation or to create multi-layer circuitry!
Bare’s Electric Paint Pens are a great electronics prototyping tool for makers of all ages. Nontoxic and water-soluble, they can be used without gloves or mask. Once applied the paint dries quickly at room temperature, and can be removed with soap and water.
Note!
Electric Paint is not meant for use on skin! Also, Electric Paint is not waterproof, but depending on what your application is you can paint over it with a waterproof paint or varnish. On the bright side this does make for easy cleanup.Features:
- Water-based, nontoxic and dries at room temperature.
- Electric Paint can be applied to a wide variety of materials, including (but certainly not limited to) paper, cardboard vellum, wood, metal, plaster, some rubbers, plastics and many textile.
- Soap and warm water will take Electric Paint off of most surfaces.
- Can last years if treated properly and kept dry.
202160
Manufacturer BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
Responsible person BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
Other products in the same category (16)
The Arduino UNO WiFi board is based on the ATmega328 and it has an integrated ESP8266 WiFi Module. If you are starting out with Arduino, or starting with IoT, this is the board to get. A000133
Retired
No product available!
ZigBee module with an output power of 1 mW (+0 dBm) and a data transmission speed of up to 250 kb / s. Range up to 100 m. The module has 6 ADC lines (10-bit) and 8 GPIO lines. Requires an external antenna for the U.FL connector. SparkFun WRL-08666
Retired
No product available!
No product available!
The controller can control two brush motors, communicating with the master system using USB Micro-B, TTL serial interface, analog signals, as well as signals from the RC apparatus. The current capacity of 5A / channel allows you to control high-power motors. Polol 2394
Retired
No product available!
No product available!
A set for building a four-wheel, remote-controlled vehicle. Equipped with a programmable Arduino Uno R3 controller and set of sensors. modARD_02
Retired
No product available!
No product available!
No product available!
I-NUCLEO-LRWAN1 is a board with an integrated solution that enables everyone to learn and develop solutions using LoRa® and / or FSK / OOK technology
Retired
No product available!
No product available!
No product available!
No product available!
No product available!
No product available!
No product available!
Processor charger designed for Li-Ion cylindrical batteries in various sizes (including 18650). It can charge batteries both with PCM protection and without protection. The nominal charging current in the main phase is 1A. XTAR MC1S
Retired
No product available!
Bare Conductive’s Electric Paint is just like any other water-based paint… except that it’s electrically conductive! This means that you can actually paint wires onto things like models, clothes, furniture, walls, almost anything you can think of. COM-11521