The board with the RP2040 microcontroller equipped with two ARM Cortex-M0 + cores operating at a frequency of 133 MHz, 264 kB RAM. The board also has 2 MB of QSPI flash memory. In addition, the board is equipped with the Infineon CYW43439 system, extending the board with wireless connectivity. Version with soldered connectors. Raspberry Pi SC0919

Evaluation board for STM32F103 microcontrollers

Development kit with STM32L496ZGT6 microcontroller (ARM Cortex-M4 core) with a built-in ST-Link programmer. Extensive equipment, including: MEMS 6DoF sensor, motor controller, joystick, LED display, 8 LED diodes, RGB LED, audio amplifier, Flash memory QSPI 1 MB, microphone, Arduino connector

Development kit with STM32L496ZGT6 microcontroller with built-in ST-Link programmer. Extensive equipment, including: MEMS 6DoF sensor, motor controller, joystick, LED display, 8 LED diodes, RGB LED, audio amplifier, Flash memory QSPI 1 MB, microphone.

Bi-directional 8-channel logic level converter module (1.2-3.6V to 1.7-5.5V) based on TXB0108 chip.

The board with the RP2040 microcontroller equipped with two ARM Cortex-M0 + cores operating at a frequency of 133 MHz, 264 kB RAM. There is as much as 16 MB of QSPI flash memory on the board. The system can be programmed in C / C ++ or microPython. KApico RP2040

The board with the RP2040 microcontroller equipped with two ARM Cortex-M0 + cores operating at a frequency of 133 MHz, 264 kB RAM. There is as much as 16 MB of QSPI flash memory on the board. The system can be programmed in C / C ++ or microPython. Soldered connectors. KApico RP2040

The KAmod BlackPill 411 is an evaluation board featuring the STM32F411CEU microcontroller, offering versatile programming and communication capabilities via USB-C. Compatible with the BlackPill project, it stands out with a modified power circuit, ESD protection, and a pre-installed bootloader for Arduino IDE support. With 32 GPIO pins, an SWD interface, and RTC support, it is an ideal solution for various embedded projects

The KAmod BlackPill 401 is an evaluation board featuring the STM32F401CCU microcontroller, equipped with a USB-C connector with ESD protection and a modified power circuit. With a pre-installed bootloader, it supports Arduino IDE, offering 32 GPIOs and versatile programming and communication capabilities

The Kamod BluePill+ evaluation board equipped with the STM32F103C8T6 microcontroller offers improvements over the original BluePill, such as a new PCB design, a USB-C connector with ESD protection, an improved power supply circuit, and the ability to program via Arduino IDE and STM32CubeIDE

The KAmod BlackPill 401 is an evaluation board with an STM32F401CCU microcontroller, featuring USB-C with ESD protection and a modified power circuit. With a pre-installed bootloader, it supports Arduino IDE, offering 32 GPIOs and versatile programming capabilities

The KAmod BlackPill 411 is an evaluation board featuring the STM32F411CEU microcontroller, offering versatile programming capabilities with a USB-C connector and a pre-installed bootloader compatible with Arduino IDE. Equipped with 32 GPIOs, a modified power circuit, and ESD protection, it is perfect for embedded projects.