SATO1004 Plus - Micsig's portable Automotive oscilloscope

Description

The Micsig Automotive Series Portable Oscilloscope is a digital oscilloscope with an 8 inch LCD touch screen display and integrated automotive diagnostic software. The device has four channels and has good measurement parameters: 100 MHz band, 1 GSa/s sampling rate and 70 Mpts memory buffer. It has numerous outputs that allow you to connect to another device via USB 3.0 and 2.0, USB type C, HDMI and WiFi. In addition, the oscilloscope is equipped with a power connector and a battery with a capacity of 7500 mAh, which allows you to work up to 5 hours on a single charge. The housing also has a stand that allows you to place the oscilloscope at an angle of 45° in a convenient way to work.

The oscilloscope has a built-in integrated software for car diagnostics. The software supports all the necessary functions helpful in the automotive industry - from the analysis of the charging and ignition system operation, through sensors, actuators and pressure tests.

The basic diagnostic functions include:

• Ignition test
• Test of actuators: solenoids, glow plugs, IAC, injectors, pressure regulator, throttle
• Sensor test: ABS, air flow, acceleration, camshaft, temperature, Lambda probe, throttle position
• Pressure test: intake manifold, exhaust pipe, cylinder, connecting rod
• Charging circuit test

The oscilloscope has built-in support for communication using protocols widely used in automotive: CAN, LIN, Flexray and K-line.

The oscilloscope has 32 GB of built-in memory, so that the user can store screenshots directly on the device, and the built-in quick save function greatly simplifies and simplifies the data recording process. The manufacturer also provides the oscilloscope with applications available for PCs and mobile devices with Android and iOS. This allows you to conveniently use the device remotely.

The set with the device includes BNC probes, power supply and accessories facilitating work with the oscilloscope.

Features

• Band: 100 MHz
• Channels: 4
• Sampling rate: 1 GSa/s
• Memory buffer: 70 Mpts
• Capture speed up to 130,000 wfm/s
• Bandwidth Limitation: Low Pass
• Outputs: Wi-Fi, HDMI, USB 3.0 and USB 2.0, USB Type-C, GND, DC power, trigger output
• Display:
  • TFT LCD 8"
  • Resolution 800x600 pixels
  • Display range 14x10
  • Capacitive touch screen
• Built-in 32 GB memory, waveforms and screenshots can be viewed and edited in the oscilloscope
• Android and iOS and PC applications for remote control
• Battery: 7500 mAh (working time up to 5 hours)
• Dimensions: 265 x 192 x 50 mm

Kit contains

• Micsig SATO1004 Plus oscilloscope
• 2 x BNC probe
• 12V 4A power supply
• Power plug
• 5 x BNC colored protective cap
• Protective foil
• 4 x Alligator Clips
• 4 x BNC to Banana Adapter
• 4 x Flexible tip