- Out-of-Stock
PmodBT2
ID: 185425
PmodBT2 - Bluetooth Interface
PmodBT2 - Bluetooth Interface
The PmodBT2 is a powerful peripheral module employing the Roving Networks RN-42 to create a fully integrated Bluetooth interface.
The PmodBT2 uses a standard 12-pin connection and communicates via UART. There is a secondary SPI header on the board for updating the RN-42 firmware if needed.
Note:
There are two UART signal pin assignment conventions in use on Digilent products. This product uses the new signal assignment convention. Connecting a product using the new convention with one using the old convention requires the use of a UART Crossover Cable (not included). Click here for a more detailed explanation.
Key Features:
- Bluetooth 2.1/2.0/1.2/1.1 Compatible
- A wide range of modes including: Slave Mode, Master Mode, Trigger Master Mode, Auto-connect Master Mode, Auto-connect DTR Mode, and Auto-connect ANY Mode.
- Simple UART Interface
- Small size: (0.8" x 1.5")
- Ships with a 6" 12-pin cable, a 6" 2x6-pin to dual 6-pin cable, one 12-pin header, and two 6-pin headers.
Download:
Code: 210-214
185425
Manufacturer BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
Responsible person BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
You might also like
The BLE 4.0 Bluetooth module with the CC2541 system has an integrated PCB antenna and an extensive AES security system. Thanks to the built-in system CC2541 from Texas Instruments, it is possible to create a project without the use of an additional microcontroller. modCC2541
zł28.87
24h
Available quantity: 5
Available
A compact development board that uses the ESP32-PICO-MINI chip. It provides wireless communication via Bluetooth and serves as an easy-to-configure UART converter. It has a built-in PCB antenna. SparkFun WRL-24113
zł93.47
24h
Available quantity: 1
Available
Other products in the same category (16)
This in-system programmer can be used to program AVR microcontrollers and AVR-based controller boards, such as our Orangutan robot controllers and the 3pi robot. Pololu 3170
Retired
No product available!
EXtreme CC312U 3100mA power supply / car charger with two USB ports, allows you to charge phones, navigation, mp3 / mp4 players and connect Raspberry Pi computers
Retired
No product available!
AVT kit for self-assembly of an extremely effective bomb clock. AVT3128 B
Retired
No product available!
AVT kit for self-assembly of the battery capacity meter and the level of battery consumption. AVT5500 B
Retired
No product available!
433M wireless module for SPI interface, vertical pinheaders, 1.27mm pitch
Retired
No product available!
high performance e-compass, 3D accelerometer and 3D magnetometer module, I2C interface, LSM303DLHC on board
Retired
No product available!
three-axis digital output gyroscope, three-axis angular rate sensor module, I2C/SPI interface, L3G4200D on board
Retired
No product available!
High-power brushed DC motor with a 120:1 reduction gearbox, intended for operation at 4.5 V, 9.7mm-long gearbox, 3 mm-diameter D-shaped output shaft that is perpendicular to the motor shaft, and a built-in safety clutch. Pololu 1511
Retired
No product available!
High-power brushed DC motor, 120:1 reduction gearbox, intended for operation at 4.5 V, 9.7mm-long gearbox, 3 mm-diameter D-shaped output shaft that is offset from but parallel to the motor shaft, built-in safety clutch. Pololu 1512
Retired
No product available!
This compact, inexpensive plastic gearmotor (brushed DC motor with a 120:1 reduction gearbox) is well suited for use in small robots. While intended for operation at 4.5 V, it should run comfortably in the 3 V to 6 V range.
Retired
No product available!
Raspberry computer case: Pi 3 model B +, Pi 3 model B, Pi 2 model B and Pi 1 model B + in gray with metal
Retired
No product available!
Battery: Li-Ion; 3.7V; 1000mAh; Outputs: wires with 2-pin JST-PH connector; 50.8 mm x 33.5 x 5.9 mm. PRT-13813
Retired
No product available!
No product available!
This breakout board for TI’s DRV8880 microstepping bipolar stepper motor driver features adjustable current limiting, overcurrent and overtemperature protection, and six microstep resolutions (down to 1/16-step).
Retired
No product available!
Wheels fit 2 mm diameter output shafts such as the ones on our sub-micro plastic planetary gearmotors. Pololu - 2356
Retired
No product available!
JEKEN CE-6200A ultrasonic cleaner, with digitally adjustable working time, power 70 W and a capacity of 1.4 l. It is well suited for repair and maintenance of electronic components, PCBs, optical elements, as well as for the dissolution of polymers
Retired
No product available!
PmodBT2 - Bluetooth Interface