Qwiic Cable - adapter Qwiic - Grove 100mm

The expansion module is designed to work with Raspberry Pi 400 - a  portable computer built into the keyboard. The board has a 40-pin connector in the pin position and two Qwiic connectors. SparkFun DEV-17512

Set with OpenLog Artemis data logger. The set includes an I2C expander, a strain gauge module, a USB type C cable, a 1250 mAh LiPo battery, a 1 GB microSD card and all the necessary Qwiic cables. SparkFun KIT-18295

ToF distance sensor (Time of flight) with a range of up to 5 m. The module is supplied with the voltage of 3.3 V and communicates via the I2C interface. SparkFun SEN-19218

DEV-14477

Module with 4 relays JZC-11F with a load of 5A. It enables switching devices with high power using a microcontroller. I2C communication. SparkFun COM-16566

Module with integrated proximity and ambient light sensors and IR emitter in the VCNL4040 system. It allows the detection of obstacles in the range of 0 to 20 cm (no dead zone). It communicates via the I2C bus. SparkFun SEN-15177

DEV-14495

PRT-14417

Qwiic adapter designed for micro:bit educational modules. Facilitates access to all pins that are led out on the connector with a pitch of 2.54 mm and the Qwiic connector. SparkFun BOB-16446

GPS module with 72-channel GNSS NEO-M8U receiver. The system can receive data from all major positioning systems: GPS, GLONASS, Galileo and BeiDou. It has UART, I2C and SPI interfaces. Built-in accelerometer and gyroscope. SparkFun GPS-16329

Intermediate module of the communication system based on QwiicBus. It allows you to extend the range of the I2C bus. SparkFun COM-18000

Module with 10 addressable RGB LEDs APA102C. Each of the LEDs is independently controlled via the I2C interface, and the line address is modified, so that the modules can be connected with each other. SparkFun COM-18354

Module with 4 Qwiic connectors for Teensy boards. Communication via the I2C interface. SparkFun DEV-17119

Module with digital barometer BMP581. It enables pressure measurement in the range from 300 to 1250 hPa with an accuracy of ± 5 Pa and communicates via I2C. SparkFun SEN-20171

The expansion module is designed for micro:bit sets. Offers a simple, beginner-friendly robotics controller. SparkFun DEV-15713

Module with relay up to 5.5 A and 240 V AC controlled by the I2C interface. SparkFun COM-15093