- Out-of-Stock
![AVT5360 B AVT5360 B](https://kamami.pl/16450-large_default/avt5360-b.jpg)
The possibility of speed control is one of the basic requirements for drive systems. In commutator 1-phase motors used in "small" appliances and small power tools, the regulation is uncomplicated and is based on the principle of phase regulation.
The most common in such systems are specialized integrated circuits, e.g. U2008B or KDSF hybrid systems. Unfortunately, speed control in drives with an induction motor, asynchronous (with a condenser) is not so banal, and this type of motors are most often used in small machine tools. The presented device solves the problem of speed control of an asynchronous motor.
Recommendations: the inverter will be useful in machines with electric drive to regulate the cutting speed, cutting, spinning, etc.
Basic parameters:
A detailed description in EP09 / 12 or
Note: the inverter's electrical system is not galvanically isolated from the power grid, so we did not provide the ISP connector on the PCB and the processor must be programmed before inserting into the stand. We warn against attempting to connect the programmer to the processor placed in the system. This may result in a programmer, computer failure and electric shock!
Neodymium rectangular magnet with dimensions of 3x3mm a and a height of 3 mm.
No product available!
Hardware extension adds 863 to 870 MHz radio communication capability to Open4, EvoPrimer and STM32 Primer2 platforms
No product available!
No product available!
Male terminal block, angled, 7-pin. Pitch 3.81mm. Height 7mm. 15EDGRC
No product available!
No product available!
No product available!
No product available!
The camera set with the AR1335 sensor allows you to control zoom. Works with Raspberry Pi minicomputers. The camera is equipped with a matrix with a resolution of 13 MPx. ArduCAM B016713MP
No product available!
PCB for MKP - control and measurement module with USB interface. AVT5425 A
No product available!
No product available!
OV5647 Camera Board with LS-40180 Fisheye Lens M12x0.5 Mount for Raspberry Pi 3. ArduCam B0055
No product available!
The light line has 8 LEDs type WS2812 - thanks to the built-in controller, it is possible to connect the strips in series and control them with one signal cable. NeoPixel Stick 8 x WS2812
No product available!
A small motor with a plastic gear 120:1, the output shaft with a diameter of 3mm in the shape of the "D", operating voltage 4.5 V, current consumption from 0.08 A to 0.8 A, speed 120 RPM and maximum torque 1.4 kg*cm. Pololu 1125
No product available!
No product available!
No product available!
No product available!