Category: STARTER KITS, PROGRAMMERS, MODULES

Module with an IR receiver operating at a frequency of 38 kHz. The board is equipped with a Grove connector and communicates via a digital interface. Seeed Studio 101020016

GPS module with NEO-M9N 92-channel GNSS receiver. The system can receive data from all major positioning systems: GPS, GLONASS, Galileo and BeiDou. It has UART, I2C and SPI interfaces. SparkFun GPS-15733

Module with MQ5 LPG concentration sensor. The board is equipped with a Grove connector and communicates via an analog interface. Seeed Studio 101020056

Module with 8-bit ADC and 8-bit DAC. It allows you to measure voltage and generate an analog signal. Communicates via I2C. Adafruit 4648

Development kit with QN9090 (T) Bluetooth LE 5.0 module complete with base board and expansion board. It is powered by the USB connector or from an external source via the DC connector. NXP QN9090-DK006

Module with a 1.5" black and white OLED display with a resolution of 128x128. Offers 16 gray levels and communicates via the I2C or SPI interface. Adafruit 4741

Module with a gas concentration sensor MQ2, which enables the detection of LPG, butane, propane, methane, alcohol, hydrogen and smoke. The board is equipped with a Grove connector and communicates via an analog interface. Seeed Studio 101020055

Module with EEPROM 24LC32 memory with a capacity of 32 kBit (4 kB). Equipped with a STEMMA QT connector, it communicates via the I2C interface. Adafruit 5146

Module with a light intensity sensor BH1750. The measuring range is from 1 to 65535 lux, and communication is carried out using the I2C bus. Adafruit 4681

Starter kit for the micro:bit educational module. It includes an expansion module, sensors, motor, servo and the necessary accessories. Cytron EDUBIT-NB

Module with GSR skin resistance sensor. It is used to measure skin activity, which reflects the stress response and experienced emotions. The board is equipped with a Grove connector and communicates via an analog interface. Seeed Studio 101020052

Module with a digital temperature and humidity sensor based on the SHT31-F system. Communication via the I2C interface. Equipped with a Gravity DFRobot SEN0334 connector

A module with a temperature and humidity sensor based on the AHT20 system. Equipped with a STEMMA QT connector, it communicates via the I2C interface. Adafruit 4566

Module with a digital temperature and humidity sensor based on the SHTC3 system. Communication takes place via the I2C interface. SparkFun SEN-16467

The module is designed to support incremental encoders. It reads the rotation of the encoder and transmits the information via the I2C interface. Adafruit 4991

Yellow mounting for Grove modules, which ensure convenient installation and replacement of modules in the project. Compatible with LEGO. Set of 4. Seeed Studio 110070021

The module with the buffer of the I2C bus based on the TCA4307 system. It allows you to connect I2C devices with active power supply. Equipped with a STEMMA QT connector. Adafruit 5159

Expansion board for STM32 Nucleo based on S2-LP RF transmitter operating in 868MHz band. The expansion board is compatible with ST morpho and Arduino UNO R3 connectors. STMicroelectronics X-NUCLEO-S2868A2

The expansion module is designed to work with the micro:bit educational board. It allows you to build an electronic piano. SB Components 21482

4 channel 4.8 KHz 24 bit A/D converter