Category: STARTER KITS, PROGRAMMERS, MODULES

Module with laser distance sensor ToF VL53L0X designed for M5Stack sets. It can detect simple hand gestures. M5Stack U010

Adafruit Feather 32u4 RFM95 is a development board with built-in ATmega32u4 AVR microcontroller (8MHz, 32kB Flash, 2kB RAM) and RFM95W module enabling wireless communication in the 868 MHz or 915 MHz band. The board is compatible with Arduino IDE. Adafruit 3078

Module with monostable relay. It allows you to control high-power elements with a microcontroller. Adafruit 2895

Evaluation board with ATSAMD21 microcontroller with ARM Cortex M0 core. Equipped with motion, temperature, light, sound sensors and RGB diodes. Can be programmed in MakeCode, CircuitPython, Arduino IDE or CS Discoveries. Adafruit 3333

Camera module based on ESP32 integrated with 8 MB of PSRAM. The camera is equipped with an OV3660 sensor with a resolution of 3 MPx and WiFi communication. M5Stack U082-X

Module of a small fan driven by a DC motor. The set includes two propellers with a diameter of 60 mm. M5Stack Fan Unit

Ammeter module designed for M5Stack sets. It can measure direct current in the range from 0 to 4 A with a resolution of approx. 0.15 mA. M5Stack U086

Nano I / O Shield for Arduino Nano is an expansion board for Arduino Nano that provides digital, analog pins, power inputs and a connector for the Bluetooth module. DFRobot DFR0012

Adafruit HUZZAH32 is a development board with a built-in WiFi ESP32 module. Processor frequency: 240 MHz, the module has a built-in system for charging Li-Pol batteries. The plate has soldered goldpin connectors (female extension). Adafruit 3619

Extension board designed for MicroMod main modules. Equipped with digital microphones, accelerometer and camera connector. A great tool for machine learning projects. SparkFun DEV-16400

The 32L4R9IDISCOVERY kit is a complete demonstration and development platform for STMicroelectronics Arm® Cortex^®-M4 core-based STM32L4R9AI microcontroller.

MicroMod main module with SAMD51 microcontroller. Equipped with an M.2 connector, it can work with MicroMod expansion boards. SprakFun DEV-16791

Set of M.2 connectors for MicoMod modules. Necessary when designing your own expansion board. SparkFun KIT-16549

Low-Voltage BLDC motor driver expansion board based on STL220N6F7 for STM32 Nucleo

Module with a miniature DC motor. No additional controller is required to start the engine. The module is controlled by the PWM signal. DFRobot DFR0411

Development board with Bluetooth 5.2 BGM220P module from Silicon Labs. It is equipped with a mikroBUS socket and a Qwiic connector and a 20-pin connector with peripherals such as I2C, SPI, UART and GPIO. SparkFun DEV-17588

IO port expander for M5Stack kits. Equipped with 8 IO pins and power pins, it communicates via the I2C interface. M5Stack U011-B

Module with receiver designed for communication by means of a laser beam transmitted in the air. M5Stack Laser.Rx Unit

Contrast sensor module. It has two integrated operating modes: analog and digital. It has the ability to set the digital mode for color detection. DFRobot SEN0147

The board is equipped with ATSAMD21 microcontroller with ARM Cortex-M0 core and SPI Flash memory, GPIO pins and RGB diode. Adafruit 3727