Category: Audio
Subcategories
There are 278 products.
Class-D mono audio amplifier module based on the MAX98357 chip. It can work with a 4 to 8 ohm speaker of up to 2.5 W and communicates via an I2S interface. DFRobot DFR0954
Audio preamplifier based on the NE5532 chip. Powered with symmetrical DC voltage in the range from 9 to 15 V
Audio player and recorder with built-in VS1003 codec, 3.5 mm jack audio output and a microphone
Audio amplifier module with three output channels. It can be powered from 12 to 24 V and has two 50 W outputs (left and right) and one 100 W output (bass). Equipped with Bluetooth 5.0 communication
Audio module with DAC, stereo amplifier and display, designed to work with the Raspberry Pi. Pimoroni PIM484
Module with the PAM8904 controller designed specifically to control piezoelectric elements. The amplifier operates over a wide frequency range, up to 300 kHz, and allows for gain up to approximately 13 Vpp. Adafruit 5791
A sound card in the form of a small device with a USB plug, designed to work with the Raspberry Pi and NVIDIA Jetson Nano minicomputer. Waveshare USB TO AUDIO
The PAM8403 class D stereo digital audio amplifier module is equipped with Bluetooth communication. The system allows you to connect two speakers with an impedance from 4 to 8 Ω and a power of 3 W
MEMS MSM261S4030H0 microphone module designed to work with Sipeed MAix kits. The module is characterized by high sensitivity, low noise and low cost. Seeed Studio 107990153
Speech recognition module with Nuvoton ISD9160 system, microphone, Flash memory and speaker output. The board is equipped with a Grove connector and communicates via the UART interface. Seeed Studio 101020232
The audio level indicator module with screw connection is a versatile device that makes monitoring audio levels much easier while being easy to install and use.
The module with a digital stereo audio amplifier is equipped with Bluetooth communication. The system allows you to connect two speakers with an impedance from 4 Ω to 8 Ω and a power of 15 W per channel
The module with a digital stereo audio amplifier is equipped with Bluetooth communication. The system allows you to connect two speakers with an impedance of 6 Ω or 8 Ω with a power of 6 W per channel
Mini MP3 player with microSD card support. It can work as a separate device and play sounds from the card or be controlled via the UART serial interface. DFRobot DFR0299
Audio receiver with Bluetooth 5.0 communication based on the QCC3008 module. It can be powered with the voltage from 3.6 V to 5.5 V, including with a lithium battery
Audio receiver with Bluetooth 5.0 communication based on the QCC3008 module. It is equipped with an insulated converter that enables power supply with 12 V voltage
MEMS SPU0414HR5H-SB analog microphone module. The board is equipped with a Grove connector and communicates via an analog interface. Seeed Studio 101020852
Module with a sound sensor based on an electret microphone and LM358 amplifier. The board is equipped with a Grove connector and communicates via an analog interface. Seeed Studio 101020023
LM386 audio amplifier module in a set with a loudspeaker. The board is equipped with a Grove connector and is controlled by a PWM signal. Seeed Studio 101020853
Class A power amplifier with one channel (mono) with the power of 10 W. Built on the popular design of J. Hood from 1969.