Category: Main categories
Subcategories
There are 23381 products.
Module with heart rate sensor, SpO2 (oxygen saturation) and smoke levels. It is based on the MAX30101 chip and communicates via the I2C interface. Pimoroni PIM438
Gravity: Joystick Module V2 is a joystick module with two analog outputs (X and Y axis) and a digital output (Z axis) supplied with 3.3 ... 5V voltage. DFRobot DFR0061
Laser distance sensor with a measuring range of up to 4 m based on the ToF measurement technique. Communication with the module takes place via the I2C interface. Pimoroni PIM373
Module with an IR transmitter operating at a frequency of 38kHz. The module is supplied with the voltage from 3 to 5V. FRobot DFR0095
Real-time clock module based on the RV3028 chip. It is powered with the voltage from 2 to 5 V and communicates via the I2C interface. There is also a socket with a battery on the board. Pimoroni PIM449
Module with blue LED, digitally controlled. Perfect for people starting to play with Arduino. Equipped with a Gravity interface. DFRobot DFR0021-B
Module with red LED, digitally controlled. Perfect for people starting to play with Arduino. Equipped with a Gravity interface. DFRobot DFR0021-R
Module with white LED, digitally controlled. Perfect for people starting to play with Arduino. Equipped with a Gravity interface. DFRobot DFR0021-W
Disposable biomedical electrodes that allow you to perform experimental ECG measurements. DFRobot FIT0510
A set with a radio transmitter and receiver operating at 315 MHz. The modules are equipped with Grove connectors and communicate via a digital interface. Seeed Studio 113020001
Dual MAX14870 Motor Driver is a dual DC motor controller compatible with the Arduino standard that allows you to control two DC motors with 4.5 ... 36V continuous current of 1.7A. Polol 2519
A set with a radio transmitter and receiver operating at 433 MHz. The modules are equipped with Grove connectors and communicate via a digital interface. Seeed Studio 104020002
Module with a 0.96" IPS color LCD display and a resolution of 160x80 pixels. It uses the ST7735S controller and communicates via the SPI interface. Pimoroni PIM436
Module with blue LED diode and potentiometer. The board is equipped with a Grove connector and communicates via a digital interface. Seeed Studio 104030010
Module with white LED diode and potentiometer. The board is equipped with a Grove connector and communicates via a digital interface. Seeed Studio 104030009
Module with color and light intensity sensor. Offers a wide detection range and two LED backlights. It communicates via the I2C bus. It communicates via the I2C bus. Pimoroni PIM375
Module with a 3-axis motion sensor MSA301 (accelerometer), which allows to measure acceleration in the range of ±2/±4/±8/±16 g. Communicates via the I2C bus. Pimoroni PIM456
Set of "sleeping lion" with the educational module micro: bit. It consists of a main plate, noise: bit and felt elements, thread and needle to create the toy. Pimoroni PIM363
Module with 17x7 LED matrix display (119 LEDs) designed to work with micro:bit. It uses the IS31FL3731 driver and communicates via the I2C interface. Pimoroni PIM353
Audio module with loudspeaker designed to work with micro:bit. There is an amplifier and an 8 Ω 2 W speaker on the board. Pimoroni PIM356