Category: Main categories
Subcategories
There are 23381 products.
ual MAX14870 Motor Driver is a dual DC motor driver compatible with the Raspberry Pi standard that allows you to control two DC motors with 4.5 ... 36V continuous current of 1.7A. Pololu 3758
Module with 17x7 LED matrix display (119 LEDs) designed to work with the Raspberry Pi. It uses the IS31FL3731 driver and communicates via the I2C interface. Pimoroni PIM334
The module with six touch buttons and LED diodes is designed for micro:bit. It uses the CAP1166 driver and communicates via the I2C interface. Pimoroni PIM401
HMI module with a 2.4" TFT color LCD display with a resolution of 320x240 px. Equipped with a resistive touch panel. Communication via UART interface. Nextion NX3224T024
I2C BME680 Environmental Sensor is a gas, pressure, temperature and humidity sensor in one MEMS housing. The module is supplied with 3.3-5V, for communication the I2C or SPI interface is used. DFRobot SEN0248
Network card (adapter) with USB 3.0 connector and RJ45 Ethernet socket. It enables the expansion of the computer with an additional network port with communication up to 1000 Mbps
Vorel cast iron vise for fixing to the table with a clamping screw. Maximum opening 50 mm. Vorel 36005
PIR motion sensor module for Arduino and Raspberry Pi. DFRobot SEN0018
Tic T500 USB is a stepper motor driver based on the MP6500 chip. It allows you to control the stepper motor whose voltage on the coil is 4.5-35V, the maximum current per coil is up to 1.5A. The controller can be controlled by: USB, TTL, I2C, RC (PWM model) etc. Pololu 3134
Step-Up/Step-Down converter with an output voltage of 3.3 V, an input voltage from 1.8 to 5 V and a maximum current of up to 100 mA
MYS-SAM9X35 SBC Board, MYIR
The LilyPad series module is designed for prototyping interactive e-textiles. It consists of a board with a SAMD11 microcontroller and a CR2032 battery socket, LEDs, a light sensor and a button. SparkFun DEV-14063
A nozzle with a diameter of 0.3 mm fits most heads used in 3D printers. Designed for filaments with a diameter of 1.75 mm. Made of hardened steel, making it ideal for printing, with the use of filaments with admixtures of metals, carbon and glass fibers and graphene
A set for building a mini console for arcade retro games designed to work with the Raspberry Pi. The console is connected to a TV or monitor with an HDMI input. For self-assembly. Pimoroni PIM488
Thermal printer designed for printing receipts, barcodes, bitmap graphics and QR codes. It communicates via the USB/TTL/RS232 serial interface, it can be operated e.g. by Arduino
Adapter (expansion module) with M.2 connector (A+E Key) and two SATA 3.0 sockets dedicated to LattePanda Delta and Alpha. DFRobot FIT0771
Development board with Allwinner F1C200S processor. It is equipped with 64 MB DDR RAM and 128 MB Nand Flash. It was designed to run under Linux and Python programming. DFRobot DFR0780
Love to Code Chibi Scope Display Accessory