Nova Fitness SDS011 - Laser dust / clean air sensor UART / PWM PM2.5
ID: 567804
5906623473489
zł158.55
Tax included
zł128.90 tax excl.
Laser sensor of air pollution with PM2,5 and PM10 particles. It allows for precise analysis of the amount of pollutants in the environment, has small dimensions and a built-in silent transfer fan. The data is output to the UART interface and via the PWM signal. The set includes a UART-USB converter. Nova Fitness SDS011
Description
Nova Fitness SDS011 is a laser sensor of air pollution with PM2,5 and PM10 particles. It allows for precise analysis of the amount of pollutants in the environment, has small dimensions and a built-in silent transfer fan. The data is output to the UART interface and via the PWM signal. The set includes a UART-USB converter.
properties
- Measured parameters: concentration of PM2.5 and PM10
- Measurement range: 0.0 ... 999.9 μg / m 3
- Power supply: 5 V
- Maximum power consumption during operation: 220 mA
- Current consumption at rest: 2 mA
- Permissible operating temperature: -20 ... 50 ° C
- Permissible operating humidity: 0 ... 95% RH
- Permissible operating pressure: 86 ... 110 KPa
- Response time: 1 sec
- Frequency of measurements: 1 Hz
- Minimum particle size to be detected: 0.3 μm
- Detection efficiency: 70% @ 0.3 μm, 98% 0.5 μm
- Maximum relative error: ± 15% and ± 10 μg / m 3
- Dimensions: 71 x 70 x 23 mm
Connection
| pin | Importance |
| 1 | not connected |
| 2 | PM2.5: 0 ... 999 μg / m3; PWM |
| 3 | 5 V - power supply |
| 4 | PM10: 0 ... 999 μg / m3; PWM |
| 5 | mass |
| 6 | RX UART (TTL) 3.3 V |
| 7 | TX UART (TTL) 3.3 V |
Included
- SDS011 dust sensor
- USB / UART converter
- 4-wire connection cable
567804
Data sheet
- Interface
- UART
- Type of sensor
- inny
- Power supply voltage
- 5 V
- Concentration measurement
- PM2.5/PM10
Manufacturer BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
Responsible person BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
You might also like
Laser sensor of air pollution with PM2,5 and PM10 particles. It allows for precise analysis of the amount of pollutants in the environment, has small dimensions and a built-in silent transfer fan. The data is output to the UART interface and via the PWM signal. Nova Fitness SDS018
zł147.14
24h
Available quantity: 2
Available
Other products in the same category (16)
Indoor air quality measurement module, combining two high-end Sensirion sensors – SCD41 and SEN55. It offers a comprehensive set of measurements, including CO2 concentration, volatile organic compounds (VOC), suspended dust (PM1.0, PM2.5, PM4, PM10), as well as temperature and relative humidity. SparkFun SEN-25200
zł709.81
3 weeks
No product available!
The PMSA003 air quality sensor module is designed for the Raspberry Pi. It allows you to analyze the amount of pollutants based on the concentration of PM1.0, PM2.5 and PM10 particles. SB Components 20768
zł247.80
24h
Available quantity: 1
Available
BME688 integrated gas, pressure, temperature and humidity sensor module in a single MEMS housing. It is equipped with an I2C and SPI interface. It has built-in AI functions. Waveshare BME688 Environmental Sensor
zł102.93
4 weeks
No product available!
Laser sensor of air pollution with PM2,5 and PM10 particles. It allows for precise analysis of the amount of pollutants in the environment, has small dimensions and a built-in silent transfer fan. The data is output to the UART interface and via the PWM signal. Nova Fitness SDS018
zł147.14
24h
Available quantity: 2
Available
Air quality sensor module based on the SGP40 system. It uses CMOSens technology by Sensirion and provides information on the concentration of volatile organic compounds (VOC). Adafruit 4829
zł79.42
4 weeks
No product available!
Air quality sensor based on the ENS160 chip and enclosed in a housing. It communicates via an I2C interface. DFRobot SEN0515
zł158.12
24h
Available quantity: 1
Available
Module with PM2.5 HM3301 dust sensor. The board is equipped with a Grove connector and communicates via the I2C interface. Seeed Studio 101020613
zł150.23
24h
Available quantity: 1
Available
Digital gas sensor solution that senses a wide range of Total Volatile Organic Compounds (TVOCs), including equivalent carbon dioxide (eCO2) and metal oxide (MOX) levels, intended for indoor air quality monitoring in personal devices such as watches and phones, but we’ve put it on a breakout board so you can use it as a regular I2C device. SEN-14193
zł193.38
24h
Available quantity: 2
Available
Laser dust sensor is a digital universal particle concentration sensor,it can be used to obtain the number of suspended particulate matter in a unit volume of air within 0.3 to 10 microns, namely the concentration of particulate matter, and output with digital interface, also can output quality data of per particle. DFRobot SEN0177
zł260.24
24h
Available quantity: 4
Available
Air quality sensor module based on the ENS160 system. It communicates via the I2C interface (Gravity connector). DFRobot SEN0514
zł97.10
24h
Available quantity: 2
Available
Module with environmental sensors for Raspberry Pi Pico. It allows you to measure temperature, humidity, air quality pressure and color detection. SB Components 22366
zł208.80
24h
Available quantity: 3
Available
BME680 integrated gas, pressure, temperature and humidity sensor module housed in a single MEMS housing. It is equipped with an I2C and SPI interface. Waveshare BME680 Environmental Sensor
zł57.75
4 weeks
No product available!
Laser sensor of air pollution with particles PM1,0, PM2.5 and PM10. It allows for precise analysis of the amount of pollutants in the environment, has small dimensions and a built-in silent transfer fan. Data is output to the UART interface. PMS3003
zł95.25
24h
Available quantity: 38
Available
Air quality sensor module based on the ENS160 system. It communicates via the I2C or SPI interface. DFRobot SEN0515
zł69.22
24h
Available quantity: 2
Available
Total suspended particulate (TSP) sensor that allows you to measure the particle concentration from 1 to 100 μm. SDS198
zł435.31
24h
Available quantity: 1
Available
Available
Laser sensor of air pollution with PM2,5 and PM10 particles. It allows for precise analysis of the amount of pollutants in the environment, has small dimensions and a built-in silent transfer fan. The data is output to the UART interface and via the PWM signal. The set includes a UART-USB converter. Nova Fitness SDS011