Best sellers

The most popular Sn60Pb40 SW26 solder is a high-quality lead product with SW26 flux, intended for professional soldering in electronics and electrical engineering, meeting the EN ISO 9453:2014 standard

Oscilloscope probe designed to analyze signals generated by the ignition coil in car engines. It is compatible with most digital oscilloscopes. Hantek HT20COP

Adrian Kaehler, Gary Rost Bradski

A set of two crocodile clips in the form of caps for the HT30A probe. Terminal length 85 mm, supplied with black and red cover. Hantek HT18A

128x64 pixel graphic display, STN NEGATIVE BLUE, with white LED backlight. Display based on RA8808 driver compatible with KS0108 with the possibility of control via SPI interface. LCD-EG-128064H-BHW W/B-E6

VL53L0X ToF Laser Range Finder is a laser distance sensor using the ToF (Time of Flight) measurement technique. The module is supplied with 3.3 ... 5 V voltage and can measure up to 2 m. DFRobot SEN0245

A small module with a 1.54" LCD display and a resolution of 240x240 pixels, equipped with a WiFi ESP-12E module. It is programmed via a USB type C connector. SB Components 25626

NB-IoSIM7000C Arduino NB-IoT / LTE / GPRS / GPS Expansion Shield is an advanced expansion board for Arduino. It has support for SIM cards and NB-IoT cards. Thanks to the GNSS module (Global Navigation Satellite System), it supports GPS, GLONASS, Galileo, QZSS and BeiDou GPS navigation systems. The module is powered by 7 ... 12V voltage. DFRobot DFR0505

Pmod HAT Adapter allows you to attach Pmod extensions to the Raspberry Pi computer. The overlay contains 3 Pmod ports and also allows access to the 40-pin PC expansion connector. Digilent 410-366

LM75ADP, Digital temperature sensor and thermal watchdog 10-bit, -55°C do 125°C, TSSOP8

Vorel cast iron vise for fixing to the table with a clamping screw. Maximum opening 70 mm. Vorel 36008

Advanced signal generator with two channels and an output frequency range from 1 uH to 200 MHz. It allows you to generate various signals, such as sine, square, triangle, pulse, noise, harmonics, and has 150 built-in arbitrary waveforms. Hantek HDG6202B

Board with USB-Type A connector (female) with USB pins connected to the goldpin connector (2.54mm)

Permanent cylindrical neodymium magnet with a diameter of 8 mm and a height of 4 mm. Set of 10 pcs

E-Ink display (ePaper) with a diagonal of 1.54 "and a resolution of 200 x 200 pixels with a SPI controller. Waveshare 1.54inch e-Paper (B)

Waveshare AlphaBot, a development kit for building an Arduino-based robot

7 "LCD TFT display module, 800 x 480 pixels (8: 5) resolution, 8080 interface, LED backlight, I2C touch panel, Waveshare 7inch Capacitive Touch LCD (C)

USB converter module - FIFO, FT245 with mini USB and goldpin connector

The evaluation kit designed for the nRF51822 Bluetooth 4.0 system consists of the BLE400 base board and the Core51822 wireless module with the nRF51822 chip. Waveshare NRF51822 Eval Kit

100cm flexible cable (tape) for connecting the camera module to Raspberry Pi computers. The tape has 15 wires and 1mm pitch