Best sellers
There are 16462 products.
Cap for Xbee and Arduino. It has been designed for wireless sensor networks such as WiFi, Bluetooth 2.0 / 4.0 and Zigbee. DFRobot DFR0015
Yellow mounting for Grove modules, which ensure convenient installation and replacement of modules in the project. Compatible with LEGO. Set of 4. Seeed Studio 110070025
Module with a slide potentiometer. Depending on the position of the slider, the resistance value (maximum resistance 10kΩ) changes, which translates into the voltage value at the analog output of the module. The module has a connector in accordance with the Grove standard. Seeed studio 101020036
Module with Sensirion SCD30 sensor, which enables CO2, temperature and humidity measurement. The board is equipped with a Grove connector and communicates via the I2C interface. Seeed Studio 101020634
LED strip with COB diodes in green. It is powered by 12 V DC, has a length of 5 m and 384 LEDs/m. Protection level IP20
Nucleo-32 series board equipped with STM8S207K8T6C microcontroller with built-in programmer-debugger ST-Link v.2.1, connectors compatible with Arduino Nano.
Transmitter and receiver set enabling wireless power supply for 12V devices. Maximum charging current up to 1A.
A set with an analog audio level indicator in the form of a panel meter. Powered with AC or DC voltage from 6 to 12 V. It consists of two VU meters, module and wires
Transmitter and receiver set enabling wireless power supply for 12V devices. Maximum charging current up to 2A.
Module with a touch keyboard (12 buttons) based on the ATtiny1616 microcontroller. The board is equipped with a Grove connector and communicates via the UART interface. Seeed Studio 101020636
Magnetic service mat for accommodating screws and metal parts. Avoids losing small parts while servicing the device
A module with a high precision temperature sensor based on the MCP9808 chip. It allows for measurements with an accuracy of ±0.25°C and communicates via the I2C interface. DFRobot SEN0435
UART-RS232 converter module. The board was equipped with a Grove and DB9 connector. Seeed Studio 103020192
BGA balls with a diameter of 0.5mm and composition Sn63/Pb37. The container has 25 000 pieces.
Module with a 16-channel PWM PCA9685 driver. The board is equipped with a Grove connector and communicates via the I2C interface. Seeed Studio 108020102
Li-Po battery 3.7V / 750mAh, PCM protection, connector 2 pins, cable length 150mm. Akyga LP403450
Module with TB6612FNG DC motors dual driver. The board is equipped with a Grove connector and communicates via the I2C interface. Seeed Studio 108020103
Extension board designed for MicroMod main modules. It is equipped with Qwiic and mikroBUS connectors. SparkFun DEV-18710
μRemote Basic in a white housing is a fourth generation pilot for controlling all devices in the home and garden. Configurable from the application, loaded like a smartphone
Module with PM2.5 HM3301 dust sensor. The board is equipped with a Grove connector and communicates via the I2C interface. Seeed Studio 101020613