Best sellers
There are 17244 products.
MCP2515-I/SO is a widely used SPI-based CAN controller that enables adding CAN bus support to microcontrollers without a built-in CAN module. It is suitable for embedded and industrial applications, provided that an appropriate external CAN transceiver is used for connection to the bus.
8-wire cable, 20 cm in length, with female JST SH-1.0 A-A connectors on both ends.
KAmodPCF8883T is a module with capacitive touch sensor PCF8883 from NXP. The module has a probe placed on the PCB and a diode indicating the state of the chip. It enables work in one of three modes.
Socket for push-push microSD cards made of metal and plastic from ATTEND
The GL5537 Photoresistor is a high power, high-speed photosensitive element that changes its height based on scattered light, covering applications in a variety of applications such as automatic flashing, control, and photoelectric systems, with an ultimate flux of 150 VDC, a dissipation power of 100 mW, and an operating temperature range of -30°C to +70°C.
Slim D-sub Connector, 9-pin Right Angle with Maximum 2.5A Current Rating, RoHS
The KAmodPCAL6408 is an 8-bit I/O expander with the PCAL6408A chip by NXP, controlled by the I2C interface.
Connector for connecting a 40-pin ribbon with a pitch of 0.5 mm to a printed circuit board. F0500WR-S-40PF
Pin strip straight in black, double-row, female with 2x20 layout, 2.54mm pitch and elongated legs (12mm). Thru-hole assembly (THT), often used to build GPIO modules for single board computers. PBD40S L
Female connector MOLEX 90142-0020 from the C-Grid III series, featuring 20 contact positions in a 2x10 layout with a 2.54 mm pitch, is designed for wire-to-board connection systems. The product is supplied without contacts, allowing for individual component selection to meet application requirements. It is used in electronic projects, industrial devices, and automation systems.
Connector for connecting a 10-pin ribbon with a pitch of 0.5 mm to a printed circuit board. F0500WR-S-10PF
Double-sided universal board 30 × 70 mm with 252 metallized holes and gold-plated contact pads. Intended for prototyping circuits with through-hole components in a standard 2.54 mm pitch.
Pin header goldpin blue 2x40 pins. Straight connector for through-hole assembly. 2.54mm pitch.
The first microcontroller designed by the Raspberry Pi foundation, equipped with two ARM Cortex M0 + cores clocked at 133 MHz, 264 KB of RAM and 30 ports with I2C, SPI, UART and USB interfaces. External flash memory can be connected via the QSPI interface. The system can be programmed in C / C ++ or microPython. Raspberry Pi SC0908
AMS1117CD-1.8, 1A low drop voltage regulator 1,8 V, TO-252
Connector for connecting a 6-pin ribbon with a pitch of 0.5 mm to a printed circuit board. F0500WR-S-06PF
THT resistor, 0.25W, 5%, RoHS
LED 0805 yellow, 100 mcd (20 mA) (2.0 V)