Best sellers
There are 15606 products.
Module with a digital distance sensor with a range of up to 5 cm. It has a digital output that goes low when an object is detected. Pololu 4050
Set with a monochrome camera with a resolution of 0.3 MPx with an OV7251 sensor and a USB 2.0 adapter. ArduCAM EK021
Set with a monochrome camera with a resolution of 0.3 MPx with an OV7251 sensor and a USB 2.0 adapter. Without IR filter. ArduCAM EK027
Unshielded UTP category 5E Ethernet network cable with RJ45 plugs. Lanberg PCU5-10CC-0500-B
Module with a digital distance sensor with a range of up to 50 cm. It has a digital output that generates a pulse with a width proportional to the measured length. Pololu 4064
Camera module based on the CMOS MT9V022 matrix with a resolution of 752x480 px (0.36 MPx). Designed for use with ArduCAM USB Shield. ArduCAM B0109
USB-UART converter based on the CP2102N chip. Compatible with a voltage of 3.3 V, it has been equipped with a USB type C connector. Adafruit 5335
Miniature camera module with OV5647 5MP sensor dedicated to Raspberry Pi Zero and Compute Module. Equipped with a lens with a viewing angle of 120°. ArduCAM B006604
Camera with OV4689 CMOS sensor with a resolution of 2688x1520 px. It communicates via a parallel interface. ArduCAM U6035
Camera with a resolution of 2 MPx with a USB interface. Equipped with a CMOS IMX291 sensor with an ultra-wide lens with a viewing angle of 120°, a microphone and a case. ArduCAM UB020101
A pin expander designed for Raspberry Pi Pico boards. It is equipped with a standard female connector and four sets of male strips 2x20 pins. SB Components 21352
USB adapter designed for XBee modules. It can be connected to a computer with a USB cable and used with the X-CTU software to configure the XBee. DFRobot DFR0174
Module with a 2-channel driver for DC motors L293D designed to work with the Raspberry Pi Pico. It can work with a voltage from 6 to 12 V and a current of up to 600 mA. SB Components 21468
Test kit with 6 Pogo Pin spring probes designed to work with boards with an ISP connector. It enables the programming of the set without the need to solder the pins. SparkFun KIT-11591
The charger module is designed for 3 Li-Ion cells. It is equipped with a micro USB and USB type C connector and supports fast charging (QC).
INA169 current sensor module. The system can be supplied with the voltage from 2.7 V to 60 V and has an analog output. SparkFun SEN-12040
Camera module with OV9782 sensor designed for DepthAI systems, including the DM1090FFC base plate. ArduCAM B0335
The expansion board with the LoRa E22-400T22S module for the Raspberry Pi Pico. It supports the LoRaWAN protocol and allows communication in the 433 MHz frequency band. SB Components 21642
A simple adapter with a microUSB type B connector for goldpin with a 2.54 mm pitch. Perfect for use with a breadboard. SparkFun BOB-12035
Universal charger with dual charging sockets designed for Li-Ion, LiPo, LiFe, LiHV, Pb and Ni-MH batteries. It has a power output of up to 500 watts, allowing up to 25 amps of charging current. ToolkitRC M6D