Best sellers

USB 3.0 flash memory with a capacity of 256 GB, optimized for use with Raspberry Pi computers, designed for data storage as well as installing and running operating systems. Raspberry Pi

USB 3.0 flash drive with 128GB capacity, optimized for use with Raspberry Pi computers, designed for data storage as well as installing and running operating systems. Raspberry Pi

Adafruit 2455 - PiTFT 2.4" HAT Mini Kit - 320x240 TFT Touchscreen

Cable with USB plugs type A and micro-USB type B, cable length 1m. The cable has a red nylon braid

32-bit microcontroller from the STM32L4 family with ARM Cortex-M4 core, 1MB Flash memory, 128kB SRAM, 48MHz, I2C, SPI, UART / USART, USB, CAN, SWPMI, 1.71 ... 3.6V, 100LQFP, STM, RoHS

Intermediate Kit for Arduino V2, The Arduino beginner kit - KIT0018

Module for learning the basics of electronic engineering; illustrates the relationship between voltage, current, and allows the generation and observation of signals. It has the ability to sample the signal up to 200kSPS in a 16-bit converter. Powered from the USB port. ADALM1000

DAGU gearmotors; 4.5V with a no load current of 190mA while possessing a gearbox ratio of 48:1 and a wheel speed of 140 RPM unloaded. axis. ROB-13302

Module with pressure, humidity and temperature sensor. It uses the I2C interface and allows the connection of additional wind sensors via the RJ11 connector. SparkFun DEV-13674

Integrated Circuit - Interface - I / O Expanders 8bit I / O Expnder, DIP16, Texas Instruments, Rohs

Aluminum extensometer beam, allowing measurement of weight up to 20 kilograms. It has four wires. It is used in kitchen scales and portable scales, it has a 21 cm cable, RoHS.

A set of 100 pieces of various colored heat-shrinkable tubing for wire insulation, 10 cm long. NAR0832

32-bit STM32F7 microcontroller with ARM Cortex-M7 core, 1MB Flash memory, 320kB SRAM, I2C, SPI, UART / USART memory, USB, CAN, 1.71 ... 3.6 V, 144LQFP, STM, RoHS

The FM tuner module with the Si4703 chip allows you to build an FM radio with RDS support. It uses the I2C bus for communication. WRL-12938

Lithium-polymer Li-Po battery with a nominal voltage of 3.7V and a capacity of 900mAh, equipped with a PCM protection circuit and a lead with a JST 2.54 2-pin connector, 150mm long. Akyga AKY0620

The Texas Instruments H-bridge allows control of two DC brush motors or one stepper motor. The supply voltage of the motor is in the range of 0-11V, maximum current efficiency 1.5A / bridge. The system has a 12WSON housing

ATTINY44A-PU

ATtiny44A-PU is a microcontroller from the AVR family in the DIP14 housing, it is equipped with memory: 2 kB Flash, 128 B SRAM, 128 B EEPROM. The power supply voltage is 4.5..5.5 V, the maximum clock speed is 20 MHz.

Industrial PROFINET to Modbus RTU/TCP protocol converter designed for integration and data exchange between automation networks. Supports a wide 9–36V DC power supply range, DIN rail mounting, and operation in harsh industrial environments. USR-PX530

Industrial Ethernet PoE switch with four 10/100Mbps PoE ports and one 10/100Mbps uplink port. Designed for powering and networking PoE devices in industrial environments. USR-ISF1005P