Best sellers
There are 12472 products.
Cooling fan powered with the voltage of 5 V with a lead out a cable with a two-pin connector with a pitch of 2.54 mm
Neodymium rectangular magnet with dimensions of 10x5mm a and a height of 1 mm. Set of 10 pcs
ARM Cortex-M3 CPU, 64kB Flash, 20kB RAM, USB, CAN, 3xUART, 2xI2C, 2xSPI, ADC, STM, LQFP48, RoHS
Low Power, Precision Analog microcontroller with Dual Sigma-Delta ADCs, ARM Cortex-M3, QFN48, Analog Devices, RoHS
Unshielded UTP category 6 Ethernet network cable with RJ45 plugs. Lanberg PCU6-10CC-0025-R
Development kit with STM32L496ZGT6 microcontroller with built-in ST-Link programmer. Extensive equipment, including: MEMS 6DoF sensor, motor controller, joystick, LED display, 8 LED diodes, RGB LED, audio amplifier, Flash memory QSPI 1 MB, microphone.
ARM®-based 32-bit MCU, 128 KB Flash, CAN, 12 timers, ADC, DAC & comm. interfaces, 2.0 - 3.6V, LQFP48, STM, RoHS
Tomasz Jabłoński, Krzysztof Pławsiuk
ModRL01 module with 10A/250VAC (10A/24VDC) relay, supply of 5 V load relay coil, additional control circuit, protected overvoltage control
Starter kit with Intel Quark D2000 microcontroller. It offers a 32-bit microcontroller, 6-axis IMU sensor, temperature sensor, USB-UART converter and CR2032 battery socket. The set has connectors compatible with Arduino. Intel Quark Microcontroller Dev Kit D2000
Internal antenna Bluetooth, ZigBee, WLAN, chip SMD, 2.45GHz, gain 0.5dBi, dimension 3.2x1.6x0.9mm, Rainsun, RoHS
NUCLEO series starter kit equipped with STM32G431KB microcontroller (128 kB Flash, Cortex-M4), with built-in programmer-debugger ST-Link-V3E, equipped with connectors compatible with Arduino Nano.
Kit with Raspberry Pi computer built into the keyboard. Equipped with a power supply, mouse, HDMI cable and 16 GB microSD card. Raspberry Pi 400 Personal Computer Kits
Compact stepper motor controller with the TMC2208 system with an operating voltage from 4.75 to 36 V. It offers smooth, quiet operation, high efficiency, various operating modes and easy configuration. It is controlled via the STEP/DIR interface and is an ideal solution for 3D printers and similar applications. BIGTREETECH TMC2208 V3.0
Connector for connecting the 24-pin tape with 0.5 mm pitch to the printed circuit board
Permanent cylindrical neodymium magnet with a diameter of 4 mm and a height of 4 mm. Set of 10 pcs
A module with 4 PC817 optocouplers. Allows you to add galvanic separation in the form of opto-isolation between electrical circuits
LED display 13.2 mm 0.52 "single, red (635nm), 24 mcd / seg (10mA), common anode, RoHS. LED1-AS-05219BMR-B
JST SH type connector, 1.0 mm pitch, surface mounted, horizontal spatial orientation. The set includes 10 connectors