Car Detection Sensor (MB8450) is a weather-resistant sensor detecting vehicles. The module has a high resolution and a measurement frequency of 4 Hz. It allows measuring obstacles in the range of 50-500 cm. The sensor uses a Micro-B USB connector. Ideal for applications such as parking sensors. The device is factory calibrated to match the sensor patterns and provides reliable long-range detection zones.
Data sheet
Manufacturer BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
Responsible person BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
The HC-SR04 ultrasonic sensor module is commonly used in conjunction with Arduino to precisely measure distances ranging from 2 cm to 500 cm, with a resolution of 3 mm. It is a good choice for projects in the field of robotics, automation and security systems. It works on the principle of emission and reception of ultrasonic waves. It works with microcontroller platforms such as Arduino, Raspberry Pi, ESP32 or STM32. modHC-SR04
URM04 v2.0 Ultrasonic Sensor
The ultrasonic distance sensor modUS-015 is based on the analysis of the delay of reflection of the ultrasonic wave from the obstacle - the range of the sensor from 2 to 400 cm with an accuracy of 0.3 cm + 1%
DFRobot SEN0153
No product available!
The ultrasonic distance sensor modUS-015 is based on the analysis of the delay of reflection of the ultrasonic wave from the obstacle - the range of the sensor from 2 to 400 cm with an accuracy of 0.3 cm + 1%
No product available!
A multifunctional module with an optical sensor for measuring the intensity of illumination, the color of the incident RGB light, the distance from the object and the detection of 3D gestures. Detection range from 10 to 20 cm, communication via I2C. SparkFun SEN-12787
Recognizes the distance of an object away from the sensor up to about 10 inches (~25cm) and the location of the object from side to side across the sensor in about a 6 inch (~15cm) span. You will be able to use I2C or UART to communicate with the ZX Sensor via an Arduino-based microcontroller as well as a computer. SEN-12780
No product available!
KAmodVL6180X is a module that allows to measure light intensity (ALS), distance to the object and recognition of gesture. It has an embedded voltage regulator and voltage level translators on signal lines. Thanks to this can be used in systems with 2.8...5.5V power supply voltage.
The GP2Y0A60SZ distance sensor from Sharp offers a wide detection range of 4″ to 60″ (10 cm to 150 cm) and a high update rate of 60 Hz. The distance is indicated by an analog voltage, so only a single analog input is required to interface with the module.
The GP2Y0A60SZ offers a wide detection range of 4″ to 60″ (10cm to 150cm) and a high update rate of 60Hz. The distance is indicated by analog voltage - only a single analog input is required to interface with the module. Pololu 2476
Suitable for outdoor applications such as car reversing sensors, security alarms, industrial inspection, etc. SEN0207
This sensor is a carrier/breakout board for ST’s VL53L0X laser-ranging sensor, which measures the range to a target object up to 2 m away.
This module features a fixed-gain, 38 kHz modulated IR sensor and a corresponding IR LED with oscillator circuit to make a tiny proximity sensor.
This module features a fixed-gain, 38 kHz modulated IR sensor and a corresponding IR LED with oscillator circuit to make a tiny proximity sensor. This low-brightness version draws an average of 8 mA at 5 V and has a typical sensing range up to approximately 12 inches (30 cm).
Adafruit VL53L0X Time of Flight Distance Sensor is a laser distance sensor using the ToF (Time of Flight) measurement technique. The module is powered by 2.8 ... 5V voltage and can measure up to 1000mm. Adafruit 3317
ToF distance sensor module based on the VL6180X system. It offers a range of up to 10 cm and communicates via the I2C interface. Adafruit 3316
Ultrasonic obstacle sensor (vehicles) with high resolution and range up to 500cm with USB interface. It allows you to perform measurements at 4Hz. DFRobot SEN0268