Qwiic Alphanumeric Display - module with a 4-element 14-segment display (white)

SEN-14347

GPS module with 72-channel GNSS ZOE-M8Q receiver. The system can receive data from all major positioning systems: GPS, GLONASS, Galileo and BeiDou. It has UART and I2C interfaces. SparkFun GPS-15193

Module with an IO pin expander based on the TCA9534 system. It allows you to add 8 GPIO pins to an I2C-controlled project. SparkFun DEV-17047

Module with PIR EKMC4607112K motion sensor, power consumption in standby mode up to 170 uA. The board communicates via I2C and is equipped with a Qwiic connector. SparkFun SEN-17374

Intermediate module of the communication system based on QwiicBus. It allows you to extend the range of the I2C bus. SparkFun COM-18000

Data logger based on the ATmega328 microcontroller. Data received via the I2C interface are saved on the microSD card. The module supports cards with a capacity of up to 32 GB. SparkFun DEV-15164

Module with BME680 sensor for measuring environmental conditions such as concentration of volatile organic compounds (VOC), atmospheric pressure, temperature and humidity. I2C or SPI communication. SparkFun SEN-16466

Module with the ATECC608A cryptographic chip. It allows you to add strong security to an IoT node, edge device, or embedded system. SparkFun DEV-18077

Module with 6-axis IMU LSM6DSO sensor, which combines a 3-axis accelerometer and gyroscope, as well as a 9kB FIFO buffer and event handling functions. Communicates via I2C or SPI. SparkFun SEN-18020

Module with DA7280 vibration motor controller and LRA (Linear Resonant Actuator) motor. It allows you to add vibration feedback from the device to the project. SparkFun ROB-17590

Module with an infrared sensor AMG8833 - a measurement matrix with a resolution of 64 pixels (8x8). It offers an accuracy of 2.5°C and the ability to detect people at a distance of up to 7 m. Communication with the sensor is via the I2C interface. SparkFun SEN-14607

GPS module with SAM-M10Q GNSS receiver. The chip can receive data from all major positioning systems: GPS, GLONASS, Galileo, QZSS and BeiDou. It has derived UART and I2C interfaces. SparkFun GPS-21834

Module with a voltage level converter 3.3 V - 5 V intended for use in the Qwiic system. It has a built-in Step Up converter providing power supply with a voltage of 5 V and a current of up to 100 mA. SparkFun SPX-17238

ENS160 gas sensor module to measure the concentration of carbon dioxide (eCO2) and volatile organic compounds (TVOC) in the air. It communicates via an I2C or SPI interface. SparkFun SEN-20844

Module with a 4-element 14-segment display. The board is equipped with a Qwiic connector and communicates via the I2C interface. SparkFun COM-16919

Flexible Qwiic cable 150 mm long. On one side it is terminated with a female Qwiic connector, and on the other side with single male goldpin connectors. SparkFun PRT-17912