.png)
- Out-of-Stock
AVT1544 A - St1s10 end of linear stabilizers
ID: 193753
ST1S10 END OF LINEAR STABILIZERS
Description
ST1S10 END OF LINEAR STABILIZERS
The integrated impulse stabilizer used in the device easily, and even with a large advantage, replaces the majority of monolithic linear stabilizers.
Monolithic impulse stabilizers have been used in power supplies for many years, but only in recent years have semiconductor manufacturers introduced to the market systems convenient to use:
adapted to work in a wide range of supply voltages without the need to modify the inductance of the choke, characterized by high current efficiency, simple application and small dimensions.
properties
- Input voltage from 2.5 to 18V
- Operating mode: current PWM, step-down
- Synchronous converter
- Operating frequency from 400kHz to 1.2MHz
- Adjusting the output voltage from 0.8V
- Dynamic short circuit protection
- Built-in soft start
- Output voltage tolerance 2%
- Stand-by current: max 6uA
- 90% efficiency
- Output current max 3A
- Connector temperature -25C ... 125C
- Enable input
The printed circuit board and documentation are included.
Detailed description EP 10/09
193753
Manufacturer
- AVT SPV Sp. z o.o.
- Leszczynowa 11
- 03-197 Warszawa
- Poland
- [email protected]
Responsible person
- AVT SPV Sp. z o.o.
- Leszczynowa 11
- 03-197 Warszawa
- Poland
- [email protected]
Other products in the same category (16)
No product available!
Integrated analogue base station RFID (front-end) of the company EM Microelectronic with a frequency of 13.56MHz. The system has a SOP20 housing
Retired
No product available!
Computer fan housing Raspberry Pi 3, Raspberry Pi 2 model B and Raspberry Pi 1 model B + in dark blue plastic color
Retired
No product available!
Case for the Raspberry PI 2 model B, Raspberry PI 1 model B+ and Raspberry PI 3 computers, manufactured from high quality acrylic. CLEAR
Retired
No product available!
No product available!
No product available!
No product available!
Infrared sensor that allows measurement of distances up to 15cm, has a built-in infrared illuminator, IR receiver and a perimeter of the received signal
Retired
No product available!
Miniature (22x13.5x6mm) WiFi module b / g / n with TCP and UDP protocols operating in standalone and access point modes. 2.0mm goldpin connector. The module is equipped with a UART interface, it is also possible to control GPIO lines (also as PWM). Powered by 3.3V. Antenna: copper wire
Retired
No product available!
Ultra miniature WiFi b/g/n module, equipped with UART, SPI, PWM and GPIO interfaces. The ability to work as an access point and in standalone mode. 3.3V power supply.HF-LPT200-1
Retired
No product available!
This transducer is about 45mm in diameter and has 4Ω impedance and should be run at about 5W
Retired
No product available!
SPIRIT1 868 MHz low power RF module with integrated microcontroller
Delivery date unknown
No product available!
Read/Write analog front end for 125 kHz RFID Basestation, SOIC16, EM Microrlectronic, RoHS
Retired
No product available!
Bitscope Micro is a miniature measuring instrument with a USB interface, it can act as an 8-channel logic analyzer (40MS / s, 3.3V or 5V) or a 2-channel oscilloscope (bandwidth up to 20MHz). In addition, Bitscope can generate a clock signal as well as sinusoidal, triangular, rectangular and saws
Retired
No product available!
High performance WLAN USB module which enables the Raspberry Pi to connect to a Wi-Fi network
Retired
No product available!
32-bit microcontroller from the STM32F4 family with ARM Cortex-M4 core, 256kB Flash, 128KB SRAM, I2C, HDMI-CEC, Irda, LIN, SPI, UART / USART, USB, DMA, PWM, 1.7 ... 3.6V, 64-LQFP
Retired
No product available!
ST1S10 END OF LINEAR STABILIZERS