- Out-of-Stock
Micro analog servo equipped with a plastic gear. A standard PWM modeling signal is used for control. The servo has a range of motion of approximately 90°. The recommended operating voltage is 4.8 V and with this voltage the servo has a speed of 0.12s/60° and a torque of 0.6 kg*cm. The cable is terminated with a standard JR/Futaba 3-pin connector. Perfect for small flying models.
Data sheet
Manufacturer BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
Responsible person BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
The Pololu 779 15 cm servo extension with two female JR connectors enables easy and flexible connection of devices with 3-pin male connectors. It is used in robotics, automation, and RC systems to integrate servos, sensors, and controllers while maintaining the appropriate pitch and line designation.
No product available!
The Pololu 780 30 cm servo extension with two female JR connectors enables flexible connection of devices with 3-pin 2.54 mm pitch connectors. The twisted-wire construction reduces EMI interference, and compatibility with RC standards makes it suitable for modeling, robotics, and control systems.
No product available!
Twisted Servo Extension Cable 12" Female - Female
No product available!
16-Channel 12-bit PWM/Servo Driver - I2C interface - PCA9685, RoHS
The servo driver module is an extension intended for minicomputers Raspberry Pi Zero / Zero W / Zero WH / 2B / 3B / 3B +. Allows you to control 16 PWM channels. Waveshare 15275
No product available!
Universal tester of servos and ESC regulators. It allows you to check the operation of the servo without the need for a transmitter and receiver
No product available!
No product available!
Intel Edison platform with built-in antenna. Intel Atom 500MHz processor, 1GB RAM, supply voltage 3.15..4.5V, I2C, I2S, SD Card, SPI, UART, USB interfaces. EDI2.SPON.AL.S
No product available!
No product available!
A stand that uses the phenomenon of magnetic levitation. It can lift objects weighing up to 500 g. Power via USB with 5V
No product available!
No product available!
No product available!
No product available!
No product available!
No product available!
Fully programmable card (PICC) emulator, simulator to characterize, test and certify contactless readers for ISO 14443, ISO 15693, NFC and FeliCa conformity
No product available!
No product available!
Graphic LCD 160x128, 129x102mm, LED backlight (White), FSTN, character generator, negative voltage generator, T6963C controller
No product available!
KAmodEPAPER is a module with a clear and energy-saving EPD (e-Paper) display of the GDE035A3 series. Thanks to the derived control signals and integrated in the inverter module, the display control is simple and no additional power lines are required
No product available!
No product available!
No product available!
Micro analog servo with plastic gear. It has a range of motion of 90°. GH-S37A