HT201 - 20:1 signal attenuator for oscilloscope

Oscilloscope probe designed to analyze signals generated by the ignition coil in car engines. It is compatible with most digital oscilloscopes. Hantek HT25COP

High voltage differential probe. It is characterized by good measurement parameters: with a 100 MHz band and an operating voltage up to 700 V. The probe has two attenuation factors: 10X and 100X. Micsig DP10007

Oscilloscope probe with BNC plug with 100MHz bandwidth. Uni-T UT-P04

Probe for measuring direct and alternating current up to 30 A. Works in the band up to 100 MHz, can be connected to the oscilloscope through the BNC connector. Powered by USB. Micsig CP1003B

Oscilloscope probe designed for the analysis of signals generated by the ignition coil in automotive engines. It is compatible with most digital oscilloscopes. Hantek HT25

Protective handbag designed for Micsig oscilloscopes of the TO, ATO and STO series.

A probe for measuring AC and DC currents up to 65 A. It operates in a bandwidth of up to 20 kHz and can be connected to an oscilloscope via a BNC connector. Hantek CC-65

Universal oscilloscope probe with BNC connector. It has a voltage divider of 10:1 and offers a frequency response of 100 MHz. It allows measurements with a maximum voltage of up to 600 V. P6100

Oscilloscope probe designed to analyze signals generated by the ignition coil in car engines. It is compatible with most digital oscilloscopes. Hantek HT20COP

Test probe tip with 10X attenuation factor. Dedicated to Micsig probes from the SigOFIT series operating in the 100 MHz and 200 MHz frequency bands. Micsig OP10-2

Product available on request. Please send your inquiry to the following address: sales@kamami.com

Insulated fiber optic probe with a measuring range up to 2500 V. It works in the band up to 800 MHz, it can be connected to the oscilloscope via the BNC connector. Comes with a 10X attenuation tip. Micsig MOIP08P

Product available on request. Please send your inquiry to the following address: sales@kamami.com

Micsig MDP series differential probe based on advanced SigOFIT technology. It offers a frequency band of 150 MHz and the ability to measure voltage up to 3000 V. It uses the popular BNC connector and is powered by a USB Type-C connector. Micsig MDP3001

6-wire test leads that allow the oscilloscope to be connected to various components in the engine compartment without stripping or puncturing the insulation and without risking damage to the connectors. Hantek HT306-1.5mm

Micsig MDP series differential probe based on advanced SigOFIT technology. It offers a frequency band of 100 MHz and the ability to measure voltage up to 1500 V. It uses the popular BNC connector and is powered by a USB Type-C connector. Micsig MDP1501

Test probe tip with 500X attenuation factor. Dedicated to Micsig probes from the SigOFIT series operating in the 100 MHz and 200 MHz frequency bands. Micsig OP500-2

Product available on request. Please send your inquiry to the following address: sales@kamami.com

A set of needle probes used for piercing wire insulation. They can be used as pin probes when working with small PCBs or connectors. Hantek HT307