.png)
- -zł1,088.69
Digilent Cora Z7-10 Kit (410-370-1)
ID: 572648
5906623491568
zł2,175.80
zł1,087.11
Save zł1,088.69
Tax included
zł883.83 tax excl.
Lowest price 30 days:
zł2,175.80
A programming platform designed on the basis of the Xilinx system-on-chip system Zynq-7000 (APSoC). The Zynq-7000 architecture integrates the ARM Cortex-A9 667 MHz processor with the Xilinx 7 FPGA chip. Digilent Cora Z7-10 (410-370-1)
Description
Cora Z7 from Digilent is a cheap and easy-to-use programming platform designed on the basis of Xilinx's Zynq-7000 System-on-Chip system (APSoC). The Zynq-7000 architecture integrates the ARM Cortex-A9 667 MHz dual core processor with the Xilinx 7 FPGA chip. This provides the ability to surround the processor with a unique set of software peripherals and controllers tailored to the target application.
The wide range of Cora Z7 hardware interfaces, from Ethernet PHY 1 Gb / s converters to analog-digital converters and general purpose input / output pins makes it an ideal platform for developing a wide range of embedded applications. The small housing and mounting holes make the Cora Z7 ready for use as part of a larger solution. Thanks to the built-in SD, Ethernet and Power card slot, the Cora Z7 solution can operate independently of the host computer.
properties
- ZYNQ processor
- Dual-core 667 MHz Cortex-A9 processor
- Programmable FPGA logic corresponding to Artix-7 FPGA
- 4400 programmable logical clusters
- 80 DSP clusters
- 270 KB block RAM
- DDR3 memory controller with 8 DMA channels and 4 high-performance AXI3 slaves
- Broadband peripheral controllers: 1G Ethernet, USB 2.0, and SDIO
- Low-band peripheral controllers: SPI, UART, CAN, I2C
- Two-channel, 1 internal analogue-digital MSPS converter
- Programmable with JTAG and microSD card
- Memory
- 512 MB of DDR3 memory with a 16-bit bus at 1050 Mb / s
- microSD slot
- Powered by USB or any external 4.5 ... 5.5V power source
- USB and Ethernet
- Gigabit Ethernet PHY with a 48-bit globally unique identifier compatible with EUI-48/64 available on the sticker
- USB-JTAG programming circuits
- USB-UART bridge
- USB OTG PHY (only supports host)
- Two buttons
- Two RGB LEDs
- Expansion connectors
- Two Pmod connectors - 16 All I / O FPGAs
- Arduino / chipKIT Shield connector
- Up to 49 digital inputs / outputs FPGA
- 6 analog inputs 0 ... 3.3V to XADC
- 8 differential 0 ... 1,0V analog inputs to XADC
- 12 additional digital FPGA inputs / outputs
Description of the system's I / O
| Number | Description | Number | Description |
|---|---|---|---|
| 1 | Power selection jumper (external / USB) | 11 | MicroSD socket |
| 2 | Power connector | 12 | USB host port |
| 3 | USB JTAG / UART port | 13 | FPGA LED |
| 4 | Extension connector | 14 | CPU reset button |
| 5 | Pmod connector | 15 | Ethernet port |
| 6 | SPI (Arduino / ChipKIT) | 16 | POWER ON button |
| 7 | Arduino / ChipKIT connector | 17 | Power LED |
| 8 | Jumper of programming mode (JTAG / microSD) | 18 | Zynq-7000 |
| 9 | User's LED | 19 | DDR3L memory |
| 10 | User button |
572648
Manufacturer
- BTC Korporacja sp. z o. o.
- Ludwinowo Zegrzyńskie 52G
- 05-140 Ludwinowo Zegrzyńskie
- Poland
- [email protected]
- 22 767 36 20
Responsible person
- BTC Korporacja sp. z o. o.
- Ludwinowo Zegrzyńskie 52G
- 05-140 Ludwinowo Zegrzyńskie
- Poland
- [email protected]
- 22 767 36 20
You might also like
Arty S7-50 is a development kit with Xilinix FPGA XC7S50-CSGA324. The board has many peripherals: slide switches, monostable buttons, RGB LEDs etc. Digilent (410-352)
zł1,104.88
24h
Available quantity: 1
Available
Arty S7-25 is a development kit with Xilinx FPGA XC7S25-CSGA324. The board has many peripherals: slide switches, monostable buttons, RGB LEDs etc. Digilent (410-352)
zł647.75
24h
Available quantity: 1
Available
A programming platform designed on the basis of the Xilinx system-on-chip system Zynq-7000 (APSoC). The Zynq-7000 architecture integrates the ARM Cortex-A9 667 MHz processor with the Xilinx 7 FPGA chip. Digilent Cora Z7-07S (410-370)
zł864.17
24h
Available quantity: 1
Available
Other products in the same category (16)
The board features a Zynq XC7Z020, Ethernet, HDMI in/out, MIC in, Audio out, Arduino Interface, 2 Pmods, 16 pin GPIO header, user LEDs, pushbuttons and Switches. 6003-410-0
Regular pricezł1,212.60zł1,008.82
24h
Available quantity: 1
Available
Arty S7-50 is a development kit with Xilinix FPGA XC7S50-CSGA324. The board has many peripherals: slide switches, monostable buttons, RGB LEDs etc. Digilent (410-352)
zł1,104.88
24h
Available quantity: 1
Available
Arty S7-25 is a development kit with Xilinx FPGA XC7S25-CSGA324. The board has many peripherals: slide switches, monostable buttons, RGB LEDs etc. Digilent (410-352)
zł647.75
24h
Available quantity: 1
Available
A programming platform designed on the basis of the Xilinx system-on-chip system Zynq-7000 (APSoC). The Zynq-7000 architecture integrates the ARM Cortex-A9 667 MHz processor with the Xilinx 7 FPGA chip. Digilent Cora Z7-07S (410-370)
zł864.17
24h
Available quantity: 1
Available
A programming platform designed on the basis of the Xilinx system-on-chip system Zynq-7000 (APSoC). The Zynq-7000 architecture integrates the ARM Cortex-A9 667 MHz processor with the Xilinx 7 FPGA chip. Digilent Cora Z7-10 (410-370-1)
Regular pricezł2,175.80zł1,087.11
24h
Available quantity: 1
Available
Development Kit Artix-7 256 MB DDR3L, 16 MB Quad-SPI flash memory, programming via JTAG
zł1,834.25
24h
Available quantity: 1
Available
Development board FPGA with ZYNQ XC7Z020-1CLG400C system, built-in USB, audio / video interfaces, JTAG programmer and compatible connector Arduino UNO R3 and Raspberry Pi. The set works with the open-source PYNQ project that combines FPGA with Python. TUL PYNQ-Z2
zł1,449.00
4 weeks
No product available!
DIP module with 36 pins, based on the Xilinx Spartan-7 FPGA chip. Provides 32 digital I/O signals and 2 analog input signals. The pins are spaced 100 miles (2.54 mm), making Cmod S7 perfect for use with breadboards. Digilent Cmod S7
zł538.89
24h
Available quantity: 1
Available
Development board FPGA PYNQ-Z1 and accessor set. Includes base plate, power supply, cables and SD card with system image for PYNQ-Z1. Digilent 240-114-1
Regular pricezł2,335.40zł1,899.00
24h
Available quantity: 2
Available
Evaluation kit equipped with Xilinx Artix 7 XC7A35T-1C FPGA chip and 256 MB DDR3 RAM. The kit is supported by Vivado and the Verilog and Lucid languages. SparkFun DEV-16527
zł791.64
3 weeks
No product available!
Platform with the AD9364 radio transmitter and receiver and the Xilinx Spartan-6 XC6SLX75 FPGA chip. Comes with enclosure. Digilent 471-042
zł9,998.93
24h
Available quantity: 1
Available
Development board with Xilinx Artix 7 chip equipped with M.2 connector. It offers a PCIe Gen2 interface and DDR3 2 Gb memory. Numato Lab NLFX1006
zł2,377.48
3 weeks
No product available!
FPGA development board with Xilinx Kintex-7 FPGA chip with 4 GB DDR3 SDRAM memory. Equipped with a fast USB 3.1 interface. Numato Lab NLFX1002-A
zł6,539.21
3 weeks
No product available!
FPGA development board with Xilinx Kintex-7 FPGA chip with 4 GB DDR3 SDRAM memory. Equipped with a fast USB 3.1 interface. Numato Lab NLFX1002-B
zł16,029.90
3 weeks
No product available!
FPGA development board with Xilinx Kintex-7 FPGA chip with 4 GB DDR3 SDRAM memory. Equipped with a fast USB 3.1 interface. Numato Lab NLFX1002-C
zł21,242.40
3 weeks
No product available!
FPGA development board with Xilinx Spartan 6 chip. Equipped with PCIe interface and two 1Gb DDR3 SDRAM memories. Numato Lab FPGAPCIE0001A
zł2,457.75
3 weeks
No product available!
A programming platform designed on the basis of the Xilinx system-on-chip system Zynq-7000 (APSoC). The Zynq-7000 architecture integrates the ARM Cortex-A9 667 MHz processor with the Xilinx 7 FPGA chip. Digilent Cora Z7-10 (410-370-1)