Category: STARTER KITS, PROGRAMMERS, MODULES

Module with a 4-element 14-segment display. The board is equipped with a Qwiic connector and communicates via the I2C interface. SparkFun COM-16919

Module with a matrix LED RGB 6x12 display (72 LEDs) designed to work with Feather plates. It communicates via a two-wire SPI interface. Adafruit 3449

A module that allows you to easily connect displays and peripherals to the Raspberry Pi using an 18-pin FPC connector and supports SPI and I2C interfaces. Equipped with two buttons, a slide switch, and a Stemma QT connector, it allows you to quickly and conveniently expand your electronics projects. Adafruit 5783

Module with a digital barometer LPS22. It enables pressure measurement in the range from 260 to 1260 hPa and communicates via I2C or SPI. Adafruit 4633

Gravity: Analog Signal Isolator is a module that allows to isolate sensors in the system and eliminate mutual interference of sensors powered by 5V. DFRobot DFR0504

Qwiic Cable - 500mm

The STEVAL-MKI063V1 board enables evaluation of the LSM303DLH sensor, which integrates a 3D accelerometer and magnetometer in a single device. With its USB interface and dedicated software, it serves as a practical tool for spatial orientation analysis and the implementation of electronic compass functions in embedded systems.

Module with an absolute pressure sensor LPS25HB. Equipped with a STEMMA QT connector, it communicates via the I2C interface. Adafruit 4530

Module with a 3-axis LIS331HH accelerometer with a configurable measuring scale of ± 6g/±12g/±24g. Equipped with a STEMMA QT connector, it communicates via the I2C interface. Adafruit 4626

BME280 integrates onboard temperature sensor, humidity sensor and barometer. It provides both SPI and I2C interfaces; and can be widely used in environmental monitoring, story height measurement and Internet of Things (IoT) control and so on. SEN0236

Cap for use with shallow Feather series, with radio module RFM95W 900MHz. It offers a range of up to 2 kilometers (the range can be increased by using an external antenna). It has a SPI interface. Adafruit 3231

J-Link BASE is a USB powered debug probe supporting a large number of CPU cores. Based on a 32-bit RISC CPU, it can communicate at high speed with the supported target CPUs. J-link BASE Compact (8.19.00)

Power module designed to work with LilyPad boards. It is equipped with a switch and a CR2032 battery socket. SparkFun DEV-13883

The Beetle shield is designed to attach a Beetle controller for easy connecting servos and sensors. DFR0285

Heart rate measurement module compatible with Arduino and Raspberry Pi (Gravity: Heart Rate Monitor Sensor For Arduino). It uses PPG technique, which in a simple and cheap way is able to measure the changing volume of blood. DFRobot SEN0203

Transparent case made of tinted plastic, designed for micro:bit educational modules. Adafruit 4852

Evaluation board with nRF52840 microcontroller. It is equipped with a USB connector and a housing, which makes it handy and looks like a small USB dongle. Adafruit 5199

Module with L3G4200D (3-axis gyroscope with digital output)

Debugger and Programmer for CCxxxx RF System-on-Chip (SoC) devices, CCxxxx RF transceivers, and CC85xx devices with PurePath Wireless Configurator

DEV-14052