Category: STARTER KITS, PROGRAMMERS, MODULES

Minicomputer with the SOM STM32MP157C. It has a dual-core Arm® Cortex®-A7 and an Arm® Cortex®-M4, as well as a PMIC power supply system, 512MB RAM and 4GB eMMC. The set consists of the SOM module and the base board. Seeed Studio 102110319

Adapter for WS2811 LED strips designed for Teensy 3.2, 3.5, 3.6 and 4.1. It uses the 74HCT245 chip and RJ45 connectors for communication with RGB LED strips. Teensy 3.2-4.1 PJRC OCTO28-ADAPTOR

Segger adapter 8.06.28 allows conversion from a 20-pin 0.1" connector to a 10-pin 0.05" Cortex-M type connector with the option of custom pin mapping. A useful solution for integrating programmers and debuggers with devices featuring different pin configurations.

Atmel AT91SAM7L-STK Starter Kit

ToF distance sensor (Time of flight) with a range of up to 5 m. The module is supplied with the voltage of 3.3 V and communicates via the I2C interface. SparkFun SEN-19037

Gravity Colorful LED is an LED twinkles with seven colors--the colors of rainbow. DFRobot DFR0474

A multifunctional module with an optical sensor for measuring the intensity of illumination, the color of the incident RGB light, the distance from the object and the detection of 3D gestures. Adafruit 3595

Gravity: I2C VEML7700 Ambient Light. Sensor SKU. SEN0228

The board is equipped with ATSAMD51 microcontroller with ARM Cortex-M4 core and SPI Flash memory, communication interfaces and RGB diode. Adafruit 3382

Module with ToF VL53L4CD sensor with a range of up to 1.3 m and a resolution of 1 mm. It is equipped with a STEMMA QT connector and communicates via the I2C interface. Adafruit 5396

CoreMP135 is an industrial development kit based on the STM32MP135DAE7 processor. It is designed for industrial automation, smart homes, and IoT gateways. M5Stack CoreMP135

ToF distance sensor (Time of flight) with a range of up to 5 m. The module is supplied with the voltage of 3.3 V and communicates via the I2C interface. SparkFun SEN-19218

Module with DA7280 vibration motor controller and LRA (Linear Resonant Actuator) motor. It allows you to add vibration feedback from the device to the project. SparkFun ROB-17590

DFRobot 315MHz RF receiver module using SC2272-L4 low power decoder chip. DFRobot TEL0112

Module with a miniature DC motor. No additional controller is required to start the engine. The module is controlled by the PWM signal. DFRobot DFR0411

MicroMod main module with Alorium Sno M2 chip. Equipped with an M.2 connector, it can work with MicroMod expansion boards. SparkFun DEV-18030

Recorder v3.0 is a module that allows you to record and play sounds. The module was based on the ISD9160FI system, it also has a FLASH memory with a capacity of 2 MB, which allows for recording up to 83 seconds long. The set contains a small loudspeaker on which recorded sounds can be played. Seeed studio 107020029