Category: STARTER KITS, PROGRAMMERS, MODULES

Module with a gesture and touch sensor. It recognizes 7 types of gestures and has 5 touch buttons. It is supplied with a voltage ranging from 3.3 V to 5 V and communicates via UART. DFRobot SEN0285

Module with a motion sensor that uses the Doppler effect to detect moving objects using microwaves. It is powered with the voltage of 5 V and has a digital output (Gravity connector). DFRobot SEN0192

Module with a PIR motion sensor. It can detect movement up to 7 meters with a detection angle of 100 degrees. DFRobot SEN0171

Module with an ozone detection sensor that performs measurements in the range of up to 10 ppm with a resolution of 0.01 ppm. The module is equipped with an I2C interface. DFRobot SEN0321

Analog voltage divider module. It enables a 5-times reduction of the input voltage. DFRobot DFR0051

Module with 2 relays controlled by the I2C interface. Each relay can switch currents up to 25 A at 12 to 280 V AC. SparkFun COM-16810

Single board computer with NXP i.MX 8M processor with 2 GB of DDR4 memory, Gigabit Ethernet port, two USB 3.0 ports, HDMI output, MIPI-DSI, MIPI-CSI, WiFi, Bluetooth Low Energy and MicroSD card slot. MaaXBoard AES-MC-SBC-IMX8M-G

Starter kit with micro:bit v2. In addition to the micro:bit v2 board, the set includes a microUSB-USB cable, a battery basket and two AAA batteries. SparkFun DEV-17288

The IO expansion module is designed to work with the micro:bit educational board. There are 20 IO pins on the board, a buzzer, audio output and voltage stabilization circuit

Module with a TDS sensor that allows you to measure the total content of solids dissolved in water. The board is equipped with a Grove connector and communicates via an analog interface. Seeed Studio 101020753

Expansion module for Seeeduino XIAO. It is equipped with Grove connectors and a lithium battery charging system. Seeed Studio 103020312

Kit with MPX5700AP pressure sensor, syringe and tube. The board is equipped with a Grove connector and communicates via an analog interface. Seeed Studio 110020248

I2C 8-channel expander module. The board is equipped with a Grove connector and communicates via the I2C interface. Seeed Studio 103020293

Module with a MLX90640 thermal imaging camera with a 32x24 field matrix and a 110° viewing angle. The board is equipped with a Grove connector and communicates via the I2C interface. Seeed Studio 114020142

Module with a passive buzzer. The board is equipped with a Grove connector and is controlled by a PWM signal. Seeed Studio 107020109

Expansion module with Qwiic connectors. The board is equipped with a Grove connector and allows communication via the I2C interface. Seeed Studio 103020292

Module with an infrared sensor AMG8833 (matrix 8x8) designed to measure temperature. The board is equipped with a Grove connector and communicates via the I2C interface. Seeed Studio 101020557

Module with MLX90614 temperature sensor with a measurement accuracy of 0.2°C and a viewing angle of 5°. The board is equipped with a Grove connector and communicates via the I2C interface. Seeed Studio 101020894

The expansion module is designed to work with the micro:bit educational board. It allows you to build an electronic piano

Expansion module for Seeeduino XIAO. It is equipped with an OLED display, RTC, MiniSD slot, buzzer, buttons, servo connector and numerous interfaces. Seeed Studio 103030356